Home

In an oil lubricated journal bearing, the coefficient of friction between the journal and the bearing

A. Remains constant at all speeds

B. Is minimum at zero speed and increases monotonically with increase in speed

C. Is maximum at zero speed and decreases monotonically with increase in speed

D. Becomes minimum at an optimum speed and then increases with further increase in speed

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. A crankshaft is a __________ shaft.
  2. In the levers of first type, the mechanical advantage is __________ one.
  3. Lewis form factor for 14 ½° composite and full depth involute system is (where T = Number…
  4. The process extensively used for making bolts and nuts is
  5. The notch angle of the Izod impact test specimen is
  6. A key capable of tilting in a recess milled out in a shaft is known as
  7. A chain drive transmits __________ power as compared to belt drive.
  8. A spring is used to
  9. Auto frettage is the method of
  10. In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then…
  11. In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where…
  12. A fast and loose pulley drive is used when
  13. Which of the following has threads at both ends?
  14. Creep in belt is due to
  15. In case of thick cylinders, the tangential stress across the thickness of cylinder is
  16. The temperature required for full annealing in hypereutectoid steel is
  17. The resultant axial load on a bolt depends upon
  18. Eye bolts are used for
  19. The dedendum circle diameter is equal to (where φ = Pressure angle)
  20. A tap bolt
  21. When spring index increases, the value of Wahl's stress factor
  22. The velocity of sliding ________ the distance of the point of contact from the pitch point.
  23. A bolt of M 24 × 2 means that
  24. A coupling used to connect two perfectly aligned shafts, is
  25. Whether any core is required in wire ropes
  26. When the fulcrum is in between the load and effort, the lever is said to be of
  27. The included angle for the V-belt is usually
  28. The face of the tooth is the
  29. According to Indian standard specifications, 100 H6/g5 means that
  30. In a butt welded joint, the size of weld is __________ the throat of weld.