In architectural drawing ________ are often used to illustrate and detail structural components.

A. Foundation beam detail sections

B. Wall sections

C. Building sections

D. All of the above

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. In an assembly section, these parts should have their section lines left out or shown solid black:
  2. Approximately this much of the cost of product development and manufacture is determined at the design…
  3. The bounding box method for setting up an isometric drawing helps the drafter ________.
  4. Switches and relays should be shown in this position with no operating force or applied energy:
  5. A full scale technical drawing will have a scale factor of ________.
  6. In a CAD system, you can draw an ellipse by specifying these:
  7. When creating a block the drafter needs to pay particular attention to selecting a base point because…
  8. The distance a screw thread advances axially in one turn is the:
  9. The daily workload of a ________ drafter would generally include technical drawings of machine parts.
  10. The section view drawing in which one fourth of an object has been marked for removal is known as a…
  11. These plans, made by the steel fabricator, are assembly drawings for the steel structure:
  12. Drawings created with commercial software are typically saved as:
  13. EDM is the acronym for:
  14. Architectural dimensioning is usually done in ________.
  15. The primary unit of measurement for engineering drawings and design in the mechanical industries is…
  16. These are special installations of stone or concrete marking the locations of points accurately determined…
  17. The first step in creating a traditional technical drawing is to ________.
  18. Auto-CAD refers to isometric ellipses as ________.
  19. Which of the following is one of the basic types of welded joints:
  20. This is a rounded exterior blend between surfaces:
  21. This is a systematic approach that integrates the design and manufacture of products with the goal of…
  22. A projection weld is a type of:
  23. In architectural drawing ________ are often used to illustrate and detail structural components.
  24. Students can complete an associate's degree in drafting which normally takes about ________ years to…
  25. A ________ is the person responsible for verifying that the drawings in a project set are free of mistakes.
  26. Several of the tools used in traditional drafting include the following:
  27. When lettering a CAD drawing, for clarity you should limit the number of fonts to:
  28. The ________ dimension tool will place the length of an angled line.
  29. This material is used in masonry construction, most commonly for ornamental facing:
  30. This is the term for the range of tightness or looseness resulting from the allowances and tolerances…