Home

In chemical dehumidification process

A. Wet bulb temperature increases

B. Dry bulb temperature remains constant

C. Dew point temperature increases

D. Dry bulb temperature increases

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Which of the following forces does not act on a fluid at rest?
  2. The yield point phenomenon observed in annealed low carbon steel is due to the presence of the following…
  3. Pick out the wrong statement.
  4. The 'transition temperature' for ductile to brittle behaviour of steel increases with increase in the…
  5. Which of the following contributes maximum as main source of sulphur in the blast furnace charge?
  6. Brazing is the joining of metals
  7. __________ is the hardest material out of the following.
  8. Stainless steel is welded with difficulty because of
  9. The most commonly used moderator in nuclear power plants is
  10. Insulation of liquid surface can be achieved by __________ on top of its surface.
  11. Fibre reinforced plastic (FRP) are
  12. Which of the following is the correct nature of shear stress distribution along the cross section in…
  13. Powder metallurgy technique is used in the production of __________ tools.
  14. __________ has a negative co-efficient of linear expansion.
  15. Maraging steels derive their strength from the following mechanism:
  16. at 1173E; at equilibrium, what will be the number of moles of CO gas required to reduce one mole of…
  17. The bank of tubes located at the back of the domestic refrigerators are the __________ tubes.
  18. Unit of viscosity in CGS system is
  19. Friction factor for fluid flow in pipe does not depend upon the
  20. Pick out the wrong statement.
  21. Which of the following is not a dielectric material?
  22. In connection with corrosion of metals, passivation is the process that
  23. Corrosion of metals cannot be prevented by its
  24. Which of the following has the highest value of refractive index?
  25. Air-petrol ratio in an automotive petrol engine is around
  26. At absolute zero temperature, for any reaction involving condensed phases
  27. Softening of hardened steel is done by its
  28. Stainless steel is welded using
  29. Minimum number of members required to form a Public Limited Joint Stock Com-pany is
  30. With increase in __________ Knocking tendency in a spark ignition petrol engine decreases.