0.1 mm
0.4 mm
0.35
0.75 mm
D. 0.75 mm
Metal removal rate is high
High surface finish is obtained
High form accuracy is obtained
High dimensional accuracy is obtained
Turning
Grinding
Boring
Milling
Continuous chips
Discontinuous chip
Continuous chips with built up edge
None of these
Shear velocity
Chip velocity
Cutting velocity
Mean velocity
High carbon steel tools
High speed steel tools
Cemented carbide tools
All of these
Polymeric mould has been cured
Mould has been totally dried
Mould is green in colour
Mould contains moisture
Geometric progression
Arithmetic progression
Harmonic progression
None of these
0°
10°
20°
100°
Improve the accuracy of location
Reduce the tendency to over-index
Improve upon the acceleration and deceleration characteristics
Reduce the cycle time
Reduce the spindle speed
Cut gears
Give desired direction of movement to the lathe carriage
Drill a workpiece
Circular Interpolation − clockwise
Circular Interpolation − counter clockwise
Linear Interpolation
Rapid feed
Improves
Deteriorates
Does not effect
None of these
It improves tool life
It improves the surface finish
Both (A) and (B)
None of these
V-threads
Whitworth threads
Buttress threads
Acme threads
5 to 15 m/min
15 to 60 m/min
60 to 90 m/min
90 to 120 m/min
Cutting speed
Nose radius
True rake angle
All of these
πd
πdn
πdn sinα
πdn cosα
Decreases with increase in gap between the two joining surfaces
Increases with increase in gap between the two joining surfaces
Decreases up to certain gap between the two joining surfaces beyond which it increases
Increases up to certain gap between the two joining surfaces beyond which it decreases
Pull broaching
Push broaching
Surface broaching
Continuous broaching
Softer metals
Cotton fabric
Carbon
Graphite
Friction zone
Work-tool contact zone
Shear zone
None of these
Ceramic
Stellite
Diamond
Cemented carbide
List-I (Equipment) | List-II (Process) |
---|---|
P. Hot Chamber Machine | 1. Cleaning |
Q. Muller | 2. Core making |
R. Dielectric Baker | 3. Die casting |
S. Sand Blaster | 4. Annealing |
. | 5. Sand mixing |
P-2, Q-1, R-4, S-5
P-4, Q-2, R-3, S-5
P-4, Q-5, R-1, S-2
P-3, Q-5, R-2, S-1
Minimum at the beginning of the cut and maximum at the end of the cut
Maximum at the beginning of the cut and minimum at the end of the cut
Uniform throughout the cut
None of these
Wheel is too hard or wheel revolves at a very high speed
Wheel is too soft or wheel revolves at a very slow speed
Wheel is too hard and wheel revolves at very slow speed
Wheel is too soft and wheel revolves at a very high speed
50°C
100°C
175°C
275°C
High metal removal rate
Dry machining
Use of soft cutting tool
Surface finish
Cast iron
Mild steel
Brass
Aluminium
Brittle metals
Ductile metals
Hard metals
Soft metals
High speed steel
Hypo eutectoid steel
Hyper eutectoid steel
Cast iron