Home

In hydrostatic bearings

A. The Oil film pressure is generated only by the rotation of the journal

B. The oil film is maintained by supplying oil under pressure

C. Do not require external supply of lubricant

D. Grease is used for lubrication

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The ball bearings are provided with a cage
  2. In block brakes, the ratio of shoe width to wheel diameter is taken between
  3. Which of the following statement is correct?
  4. A key capable of tilting in a recess milled out in a shaft is known as
  5. A bolt
  6. In a journal bearing, the load on the bearing is __________ to the axis of the journal.
  7. The plasticity is the property of a material which enables it to
  8. For unequal width of butt straps, the thicknesses of butt straps are
  9. The edges of the plates for cylindrical vessels are usually bevelled to an angle of 80° for
  10. A tapered key which fits in a key-way in the hub and is flat on the shaft, is known as
  11. In helical gears, the distance parallel to the axis, between similar faces of adjacent teeth, is called
  12. Stress concentration is caused due to
  13. The difference between the tooth space and the tooth thickness as measured on the pitch circle, is called
  14. Which of the following statement is correct regarding power screws?
  15. The rolling contact bearings as compared to sliding contact bearings have
  16. In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then…
  17. Cap screws are
  18. The contact ratio is the ratio of
  19. The application of third type levers is found in
  20. If a bearing is designated by the number 305, it means that the bearing is of
  21. Which of the following statement is correct?
  22. Machine screws are
  23. If p = bearing pressure on projected bearing area, z = absolute viscosity of lubricant, and N = speed…
  24. The notch angle of the Izod impact test specimen is
  25. For a shoe brake, the equivalent coefficient of friction is equal to (where μ = Actual coefficient…
  26. A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as
  27. An elastic bar is fixed at the upper end and loaded at the lower end by a falling weight. The shock…
  28. In worm, gears, pitch lead angle is
  29. In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where…
  30. If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to