Home

In order to create an accurate assembly drawing the drafter should create the ________ drawings first.

A. Detail

B. Title block

C. Parts list

D. Isometric

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These…
  2. A partial auxiliary view is used to show only the ________ in the auxiliary view.
  3. Geometric primitives include shapes such as ________.
  4. There are two main types of projection:
  5. The Auto-CAD command used to combine two or more primitive shapes into a single complex 3-dimensional…
  6. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
  7. These types of pipes are generally connected with bell and spigot joints or flanged joints:
  8. These are lines drawn on a map to locate, in the plan view, points of equal ground elevation:
  9. In oblique projection, important shapes should be in this position relative to the viewing plane:
  10. The thread note for a typical bolt will include the ________.
  11. Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point…
  12. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter…
  13. The Conceptual Visual Style tool is located on the ________ toolbar.
  14. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
  15. When using the descriptive geometry method to create an auxiliary view the drafter should __________.
  16. These are joined together in the field to build a structure:
  17. PDM is the acronym for:
  18. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
  19. The site plan illustrates ________.
  20. The View toolbar will position the view of the 3-D solid toward the ________.
  21. This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment:
  22. Architectural dimensioning is usually done in ________.
  23. The MASSPROP shortcut will provide the following information.
  24. The text height for room names should be set to ________for a drawing that will be plotted to a scale…
  25. An advantage of this type of view is that each view shows the object all the way through as if it were…
  26. This type of axonometric drawing has equal foreshortening along two axis directions and a different…
  27. This is a rounded exterior blend between surfaces:
  28. An architect often relies on a ________ to complete the set of technical drawings used in the design…
  29. The Offset tool should only be used for placing ________ in an isometric drawing.
  30. In order to convert fractional inches into decimal inches ________.