Home

In radial bearings, the load acts __________ to the axis of rotation.

A. Parallel

B. Perpendicular

C. Both A and B

D. None of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. In the assembly of pulley, key and shaft
  2. A connecting rod subjected to an axial load may buckle with
  3. In designing a sleeve coupling, length of the sleeve is taken as (where d = Diameter of the shaft)
  4. The resultant axial load on a bolt depends upon
  5. When the screw in a mechanical screw jack rotates, the load kept on the top of it moves
  6. At low temperatures (say 75°C) the notched bar impact value of steel
  7. A feather key is generally
  8. Which one of the following loading is considered for the design of axles?
  9. A sliding bearing in which although lubricant is present, the working surfaces __________ contact each…
  10. The design calculations for members subject to fluctuating loads with the same factor of safety, yield…
  11. When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant…
  12. A bolt of uniform strength can be developed by
  13. The bending moment M and a torque T is applied on a solid circular shaft. If the maximum bending stress…
  14. Transverse fillet welded joints are designed for
  15. Turn buckle has
  16. Yield point in fatigue loading as compared to static loading is
  17. When the bolt is very yielding as compared to the connected members, then the resultant load on the…
  18. A double fillet welded joint with parallel fillet weld of length l and leg s is subjected to a tensile…
  19. The tension on the slack side of the belt is __________ the tension on the tight side of the belt.
  20. A spring of stiffness 1000 N/m is stretched initially by 100 mm from the undeformed position. The work…
  21. When two springs are in series (having stiffness K), the equivalent stiffness will be
  22. According to Indian standards, total numbers of tolerance grades are
  23. In a gear, having Involute teeth, the normal to the Involute is a tangent to the
  24. The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover…
  25. If a spring is cut down into two springs, the stiffness of cut springs will be
  26. Which of the following statement is correct?
  27. The ratio of endurance limit in shear to the endurance limit in flexure is
  28. The stress in the threaded part of the bolt will be __________ as compared to the shank.
  29. According to I.B.R., when the thickness of the boiler shell (t) is less than 8 mm, then the diameter…
  30. When two helical springs of equal lengths are arranged to form a cluster spring, then