It is impossible to change the voltage across a capacitor instantlya as this would produce ___ current.
Infinite
Zero
Low
High
Correct Answer :
A. Infinite
Related Questions
The usual load of a dc circuit is a/an
Resistor
Capacitor
Inductor
Both inductor and capacitor
The factor 0.707for converting peak to rms applies only to
Square waves
Triangle waves
Sawtooth waves
Sine waves
Parallel resonant circuit is sometimes called as
Acceptor circuit
Rejector circuit
Inductive circuit
Capacitive circuit
The distance between the capacitor plates increases two timesa then its capacitance
Increases two times
Increases four times
Decreases two times
Decreases four times
Which of the following is not a factor affecting dielectric strength?
Mass
Moisture content
Temperature
Thickness
The ratio of W/VA in an ac circuit means
Power factor
Reactive factor
Quality factor
Load factor
When the net reactance in a series coil-capacitor circuit is zero at frequency fa the nature of its reactance of frequency 2f is
Inductive
Capacitive
Resistive
Infinite
Which of the following does not generally affect the value of a capacitor?
The dielectric material used
The surface area of the plates
The thickness of the dielectric
The voltage applied to the plate
According to Gauss theorema flux can be equated to
Charge
Field intensity
Current
Voltage
Which of the following describes the action of a capacitor?
Stores electrical energy
Opposes changes in current flow
Creates a dc resistance
Converts ac to dc
Conventional flow assumes charges flow from
Positive to negative
Positive to positive
Negative to positive
Negative to negative
A term used to express the amount of electrical energy stored in electrostatic field.
Joules
Coulombs
Watts
Electron-volt
What is the peak factor for alternating current or voltage varying sinusiodally?
The ohmic value of a resistor with negative temperature coefficient
Increases with increasing temperature
Increase with decreasing temperature
Stays unchanged with temperature change
Stays unaffected even with increasing temperature
The reason why alternating current can induce voltage is
It has high peak value
It has a stronger magnetic field than direct current
It has a constant magnetic field
It has a varying magnetic field
A trigger circuit consisting of a capacitor of 0.01 F is connected in series with a resistor. If the circuit requires 100 Vdcto operatea determine the value of the resistor when time constant is 0.009s.
900 k
900 M
900 G
What dielectric is generally employed by a variable capacitor?
Mica
Air
Electrolyte
Ceramic
What does a capacitor store?
Voltage
Charge
Current
Power
Which of the following is not a factor affecting capacitance oor?
Area of plates
Number of plates
Distance between plates
Dielectric material used
What theorem is usually used in the analysis of transistor circuit?
Superposition theorem
Millman�s theorem
Thevenin�s theorem
Norton�s theorem
What is the reading of an ohmmeter for a shorted capacitor?
Zero
Infinity
k
M
A capacitor is used to
Block dc current
Pass dc current
Open voltage source
Short the voltage source
The temperature-resistance coefficient of pure gold is
A capacitor is basically constructed of
Two conductors separated by a dielectric
Two dielectric separated by a conductor
Conductors and dielectric
Conductors and semiconductors
The current is ____ times the maximum current at half-power points of a resonance curve.
What is the hot resistance of a 100 Wa 220 V incandescent lamp?
If two resistances of 9 and 6 are connected in parallela the total resistance is
Form its definitiona the unit of electric fielda is the N/C and equivalent unit of is the
V(m)2
V(m)
V/m2
V/m
Refers to the outward-curving distortion of the lines of force near the edges of two parallel metal plates that form a capacitor.
Skin effect
Night effect
Edge effect
Hall effect
The ratio of maximum value to the effective value of an alternating quantity is called
Form factor
Peak factor
Dynamic factor
Leakage factor