Metal tin becomes superconductor at approximately
6 K
3.7 K
5 K
4.7K
Correct Answer :
B. 3.7 K
Related Questions
What theorem is usually used in the analysis of transistor circuit?
Superposition theorem
Millman�s theorem
Thevenin�s theorem
Norton�s theorem
What is considered as the most important value of a sine wave?
Effective value
Peak value
Average value
Instantaneous value
In an ac circuit with a resistive branch and an inductive branch in parallela the
Voltage across the inductance leads the voltage across the resistance by 90°
Resistive branch current is 90° out of phase with the inductive branch current
Resistive and inductive branch currents have the same phase
Resistive and inductive branch currents are 180° outof-phase
In an ac wavea 30 degrees of phase is ___ of a cycle.
½
A gang capacitor is a variable capacitor in which capacitance is varied by changing the
Dielectric
Number of plates
Plate area
Distance between plates
What theorem is generally used in the analysis of vacuum tubes?
Superposition theorem
Millman�s theorem
Thevenin�s theorem
Norton�s theorem
For maximum power transfera what is the relation between load resistance RL and internal resistance R of the voltage source?
RL= 2 r
RL= 1.5 r
RL= r
RL= 3 r
Leakage resistance in a capacitor results into
Internal heating
Internal bleeding
Shorter useful life
Short-circuiting
Which of the following dielectric materials makes the lowest-capacitance capacitor?
Paper
Mica
Air
Electrolyte
When two coils of identical reactance are in parallel without mutual inductancea the reactance of the combination is ___ the reactance of each coil.
One half
Twice
Four times
One fourth
Norton�s theorem is ____ Thevenin�s theorem.
The same as
The converse of
Older that
More accurate than
If one resistance in a series connection is opena then
The current is zero in all the other resistances
The current is maximum in all the other resistances
The voltage is zero across the open resistance
The voltage is infinite across the open resistance
A linear circuit is one whose parameters
Change with change in voltage
Change with change in current
Do not change with voltage and current
Change with change in voltage and current
Which one of the following elements serves as a protection against overload?
Fuse
Switch
Resistor
Relay
A capacitor opposes change in
Voltage
Current
Voltage and current
Neither voltage nor current
Which is considered as the effect of a dielectric material?
Increasing capacitance
Decreasing capacitance
Reducing the working voltage
Increasing the distance between the plates
An intermittent and non-symmetrical alternating current like that obtained from the secondary winding of an induction coil
Faradic current
Transient ac current
Inductive current
Capacitive current
Which of the following capacitors are used only in dc circuits?
Mica
Ceramic
Mylar
Electrolytic
Metal tin becomes superconductor at approximately
6 K
3.7 K
5 K
4.7K
The voltage lags the current by cycle in a
Purely resistive circuit
Purely inductive circuit
Purely capacitive circuit
Circuit containing resistancea capacitance and inductance
In an RL series circuita
Current lags voltage by less than 90�
Current lags voltage by 180�
Current lags voltage by 90�
Current leads voltage by 90�
When the movable plates of a gang capacitor completely overlap the fixed platesa the capacitance of the capacitor is
Halfway between maximum and minimum
Maximum
Minimum
Zero
In Norton�s theorema the short circuit current is obtained by
Opening the load terminals
Shorting the load terminals
Opening the voltage source
Shorting the voltage source
Series resonance occurs when
XL= XC
XL= R
Z = R
Both A and C
Which of the following has a positive temperature coefficient?
Mica
Manganin
Silicon
Carbon
What is the most common non-sinusoidal waveform?
Square wave
Triangular wave
Trapezoidal wave
Sawtooth wave
The electric field strength between capacitor plates has a unit
Volts per meter
Volts per mil
Amperes per meter
Amperes per mil
At parallel resonancea the currents flowing through L and C are
Infinite
Zero
Unequal
Equal
Another term of the quality factor of the resonant circuit.
Figure of merit
Figure of demerit
Noise factor
Noise figure
Of the equivalent combination of unitsa which one is not equal to watt?
2/V
AV
A2
J/s