Related Questions
What is the correct answer?
4
__________ states that if a neighboring router sends a route to a router, the receiving router will not propagate this route back to the advertising router on the same interface.
What is the correct answer?
4
You are given a Class C network, 192.168.1.0/24. You need one network with 120 hosts
and two networks with 60 hosts. How many subnet masks do you need?
What is the correct answer?
4
With a crossover cable, which pins are crossed over?
What is the correct answer?
4
If you see a VC with an inactive status, this indicates ____________.
A. The connection between both Frame Relay DTEs is up and operational.
B. The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.
C. You are not receiving any LMI messages from the Frame Relay switch.
What is the correct answer?
4
The ___________ converts an ISDN four-wire connection to a two-wire connection.
What is the correct answer?
4
Which protocol supports VLSM?
What is the correct answer?
4
EIGRP will route for ___________.
D. IP, IPX, and AppleTalk
What is the correct answer?
4
The _________ reference point defines the connection between the NT2 and the NT1.
What is the correct answer?
4
EIGRP generates hellos every _________ seconds on LAN segments.
What is the correct answer?
4
RIP supports load balancing for up to __________ ___________ paths.
What is the correct answer?
4
Ethernet ___________ has/have both a physical and logical bus topology.
D. 10BaseT, 10Base2, and 10Base5
What is the correct answer?
4
You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
What is the correct answer?
4
On the 1900 switch, how do you enter User EXEC mode?
A. It comes up by default.
B. Enter the letter U in the menu.
C. Enter the letter K in the menu.
D. Enter the letter C in the menu.
What is the correct answer?
4
EIGRP uses the _________ algorithm to update its routing table.
What is the correct answer?
4
Which control sequence moves the cursor to the end of the line?
What is the correct answer?
4
VLSM allows you to summarize __________ back to the class boundary.
What is the correct answer?
4
When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)
A. TFTP server IP address
What is the correct answer?
4
Choose the following that a standard IP ACL can match on.
C. IP protocol information
What is the correct answer?
4
Which command defines interesting traffic?
What is the correct answer?
4
A __________ topology uses a single connection to connect all devices together.
What is the correct answer?
4
A __________ route is the best path to reach a destination within the topology table.
What is the correct answer?
4
When examining the IP routing table, an EIGRP route will be shown as what letter?
What is the correct answer?
4
When choosing a WAN solution, consider all of the following except __________.
What is the correct answer?
4
Private addressing is defined in RFC ______.
What is the correct answer?
4
The ___________ is the point where the carrier's responsibility ends and yours begins.
What is the correct answer?
4
A _________ connects two or more LANs in the same geographic area.
What is the correct answer?
4
You are given the following addressing information: 10.0.8.0/22. What type of address is this?
What is the correct answer?
4
Which of the following is not an advantage of DHCP?
A. It allows for the use of private addressing.
B. It reduces the amount of configuration on devices.
C. It reduces likelihood of configuration errors.
D. It gives you more control by centralizing IP addressing information.
What is the correct answer?
4
When configuring your terminal emulation software for a console connection, set the flow control to __________.
What is the correct answer?
4
OSPF supports a ________-layer hierarchical design.