Home

One ton of refrigeration is not equivalent to the heat removal rate of

A. 200 BTU/minute

B. 50 kcal/minute

C. 50 kJ/sec

D. 3.5 KW

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. In electrical resistance welding, distortion results from the use of improper
  2. Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed…
  3. The following type of bonding is strongly directional in solids.
  4. Fibrous fracture is normally encountered in the __________ materials.
  5. Increasing the carbon content of steel
  6. Dielectric
  7. Air intake for an air compressor should be preferably taken from
  8. Aluminium is extracted from
  9. Tesla metre per ampere (T. m/A) is the unit for the measurement of
  10. If Reynolds number is greater than 1, then the
  11. Out of the following, the alloy which has equal percentage of constituents, is
  12. Square steel key is normally strong in failure by shear & crushing. Keys are normally made of __________…
  13. __________ remains constant during the adiabatic cooling of moist air.
  14. Which of the following relationships is correct for relating the three elastic constants of an isotropic…
  15. Euler number is defined as the ratio of inertia force to __________ force.
  16. Colour comparator is used to measure the
  17. __________ is used for tying the steel columns to concrete foundation.
  18. While the recrystallisation temperature for pure metals is 0.3 Tm, the same for alloys is equal to __________…
  19. Eutectoid composition of carbon steel at room temperature is
  20. Catalyst used in the 'catalytic converter' employed in automobile exhaust line for complete combustion/oxidation…
  21. Brittleness induced due to the presence of sulphur in steel can be reduced by adding
  22. Propulsion of rocket follows from the
  23. Stainless steel is welded using
  24. Pick out the wrong statement.
  25. Working of linear variable differential transducer (LVDT) is based on the principle of variable
  26. The bolt is subjected to __________ when the nut is tightened by putting the washer beneath it.
  27. __________ stress cannot be sustained by a fluid in equilibrium.
  28. Which of the following varies as the square root of oil pressure during atomisation of fuel oil through…
  29. The unit of gc is
  30. Blow off cock is provided in steam boiler to