NAT
PAT
PAR
NAT and PAT
A. NAT
The connection between both Frame Relay DTEs is up and operational.
The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.
You are not receiving any LMI messages from the Frame Relay switch.
Change the status of the ports
Affect what the SYSTEM and RPS LEDs represent
Affect what the port LEDs represent
Change the status of all the LEDs
1
2
3
4
Administrative distance
Metric
Hop count
Cost
CIR
DE
BECN
FECN
BPG
EGP
IPP
IGP
TCP
UDP
ICMP
None of these
Traffic load
Traffic configuration
PAT
Load distribution
A
B
C
None of the above
Root port
Alternate port
Backup port
Designated port
Partially meshed
Fully meshed
Hub and spoke
Star
Authentication
Compression
Quality of Service
None of these
Subnets
Networks
True
False
% Incomplete command.
% Ambiguous command:
% Unknown command or computer name
% Invalid input detected at '^'.
ROMMON
Bootstrap
Mini-IOS
Loader
SAN
LAN
CN
SAN and CN
Network
Directed Broadcast
Host
It allows for the use of private addressing.
It reduces the amount of configuration on devices.
It reduces likelihood of configuration errors.
It gives you more control by centralizing IP addressing information.
30
60
90
120
Cisco
ITU-T Q.933
ANSI
TFTP server IP address
Verification to copy
Source filename
Destination filename
Lowest MAC address
Highest MAC address
Lowest switch ID
Highest switch ID
isdn switch-type
isdn connection-type
isdn spid1
interface serial0:15
vlan
encapsulation
trunk
frame-type
Restricting telnet access to a router
Prioritizing WAN traffic
Filtering traffic from the router
Triggering dialup phone calls
framing
linecode
clock source
interface
(config)# default-gateway
(config-if)# default-gateway
(config-if)# ip default-gateway
(config)# ip default-gateway
The lowest IP address on its loopback interface, if configured, or the lowest IP address onits active interfaces
The highest IP address on its loopback interface, if configured, or the highest IP address on its active interfaces
The highest IP address on its active interfaces, if configured, or the highest IP address on its loopback interfaces
The lowest IP address on its active interfaces, if configured, or the lowest IP address on its loopback interfaces
dialer-group
dialer-list
dialer map
dialer remote-name