Home

OSPF hellos are sent every __________ seconds on a multi-access medium.

A. 5

B. 10

C. 15

D. 40

Related Questions

  1. Which router-on-a-stick command defines the VLAN for the interface?
  2. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  3. OSPF hellos are sent every __________ seconds on a multi-access medium.
  4. A ___________ in a bit position of a wildcard mask means that the same bit position in the condition…
  5. Which of the following situations are best for DDR connections?
  6. Which is not one of the three main functions of a layer-2 device?
  7. A 1924 has _________ Ethernet interfaces.
  8. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  9. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  10. Which 1900 command enables port security?
  11. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  12. Which types of memory do not maintain their contents during a power-off state?
  13. A _________ uses Gigabit Ethernet as a media type
  14. The _______ program goes out and finds the IOS and loads it.
  15. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  16. Which of the following is stored in ROM? (Choose all correct answers.)
  17. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  18. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  19. Which of the following is true concerning ACLs?
  20. Which control sequence moves the cursor to the end of the line?
  21. Which type of traffic is sent to a group of devices?
  22. You are given a Class C network with 25 bits of networking. How many subnets do you have?
  23. You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks…
  24. Which router command would you use to view the configuration register value?
  25. When choosing a dynamic routing protocol, which of the following should not be considered?
  26. The function of the MODE button is to __________.
  27. A _________ is a network that provides a secure connection from a company to other business partners.
  28. With a crossover cable, which pins are crossed over?
  29. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  30. How many steps do LCP and NCP go through when setting up a connection?

Please do not use chat terms. Example: avoid using "grt" instead of "great".