Home
Current Affairs January 2024

What is the correct answer?

4

Pick up the wrong statement about water tube boiler in comparison to fire tube boilers

A. Former occupies less space for same power

B. Rate of steam flow is more in former case

C. Former is used for high installed capacity

D. Chances of explosion are less in former case.

Correct Answer :

D. Chances of explosion are less in former case.


Related Questions

What is the correct answer?

4

The maximum heat loss is a boiler occurs due to

A. Moisture in fuel

B. Dry flue gases

C. Steam formation

D. Unburnt carbon

What is the correct answer?

4

100% efficiency of a thermal cycle cannot be achieved because of

A. Frictional losses

B. It is not possible to achieve 0°K temperature

C. Leakage

D. Non availability of ideal substance

What is the correct answer?

4

When the cross-section of a nozzle __________ continuously from entrance to exit, it is called a convergent nozzle.

A. Increases

B. Decreases

C. Remain same

D. None of these

What is the correct answer?

4

Sulphur content of fuels is very important to the plant operators because it

A. Has high heating value

B. Retards electric precipitation

C. Promotes complete combustion

D. Has highly corrosive effect

What is the correct answer?

4

With increase in load, radiant superheater has

A. Drooping characteristic

B. Linear characteristic

C. Rising characteristic

D. Flat characteristic

What is the correct answer?

4

In an experiment to determine dryness fraction of steam, the mass of water separated was 1.2 kg in 15 mts. and the mass of steam passed out in same time was 4.8 kg. Dryness fraction is

A. 40 %

B. 25 %

C. 50 %

D. 80 %

What is the correct answer?

4

Efficiency of a thermal cycle increases by

A. Regeneration

B. Reheating of steam

C. Both (A) and (B)

D. Cooling of steam

What is the correct answer?

4

The discharge of steam in a convergent-divergent nozzle __________ after the throat (i.e. in the divergent portion of the nozzle)

A. Remains constant

B. Decreases

C. Increases

D. None of these

What is the correct answer?

4

On Millier chart, the constant pressure lines

A. Diverge from left to right

B. Diverge from right to left

C. Are equally spaced throughout

D. First rise up and then fall

What is the correct answer?

4

During polytropic process

A. Heat transfer takes place across cylinder walls

B. Work is done

C. Steam may be wet, dry or superheated after expansion

D. All of the above

What is the correct answer?

4

Fire tube boilers are those in which

A. Flue gases pass through tubes and water around it

B. Water passes through the tubes and flue gases around it

C. Forced circulation takes place

D. Tubes are laid vertically

What is the correct answer?

4

At which pressure the properties of water and steam become identical

A. 0.1 kg/cm²

B. 1 kg/cm²

C. 100 kg/cm²

D. 225.6 kg/cm²

What is the correct answer?

4

In a Tandem type compound engine, the high pressure and low pressure cylinders

A. Have common piston rod

B. Are set at 90°

C. Have separate piston rods

D. Are set in V-arrangement

What is the correct answer?

4

When the inlet pressure of steam is equal to the exit pressure, then

A. There is a pressure drop in the nozzle

B. Fluid flows through the nozzle

C. Pressure drops and fluid flows through the nozzle

D. There is no pressure drop and fluid does not flow through the nozzle

What is the correct answer?

4

The temperature of flue gases at air heater outlet should be

A. 100°C

B. Above dew point temperature of flue gases

C. Below dew point temperature of flue gases

D. Less than wet bulb temperature of flue gases

What is the correct answer?

4

In reaction turbines, the axial thrust is due to

A. Pressure drop across the rotor

B. Change in axial velocity

C. Both (A) and (B)

D. None of these

What is the correct answer?

4

The efficiency of a boiler is defined as

A. Ratio of heat actually used in producing steam to the heat liberated in the furnace

B. Ratio of the mass of steam produced to the mass of total water supplied in a given time

C. Ratio of the heat liberated in the furnace to the heat actually used in producing steam

D. None of the above

What is the correct answer?

4

Which of the following is a fire tube boiler?

A. Lancashire boiler

B. Babcock and Wilcox boiler

C. Yarrow boiler

D. None of these

What is the correct answer?

4

When the total heat of steam is h kJ/kg and the sensible heat of feed water is hf1 kJ/kg, then the factor of evaporation is given by

A. (h - hf1)/2257

B. (h + hf1)/2257

C. (h × hf1)/2257

D. None of these

What is the correct answer?

4

Alkaline pyrogallate is used in Orsat's apparatus for absorption of

A. CO₂

B. CO

C. O₂

D. N₂

What is the correct answer?

4

The capacity of induced draft fan compared to forced draft fan in a boiler is

A. Same

B. More

C. Less

D. Less or more depending on size of boiler

What is the correct answer?

4

Cochran boiler is a

A. Horizontal fire tube boiler

B. Horizontal water tube boiler

C. Vertical water tube boiler

D. Vertical fire tube boiler

What is the correct answer?

4

Pick up the wrong statement about water tube boiler in comparison to fire tube boilers

A. Former occupies less space for same power

B. Rate of steam flow is more in former case

C. Former is used for high installed capacity

D. Chances of explosion are less in former case.

What is the correct answer?

4

A turbine is said to have an axial discharge when the steam leaves the blade tip at _________ to the direction of the blade motion.

A. 60°

B. 90°

C. 180°

D. 270°

What is the correct answer?

4

The ratio of the useful heat drop to the isentropic heat drop is called

A. Condenser efficiency

B. Nozzle efficiency

C. Boiler efficiency

D. Vacuum efficiency

What is the correct answer?

4

Water boils when its vapour pressure

A. Equals that of the surroundings

B. Equals 760 mm of mercury

C. Equals to atmospheric pressure

D. Equals the pressure of water in the container

What is the correct answer?

4

Which of the following boilers is best suited to meet fluctuating demands?

A. Babcock and Wilcox

B. Locomotive

C. Lancashire

D. Cochran

What is the correct answer?

4

The diameter of superheated tubes in a locomotive boiler is

A. 13 mm

B. 31 mm

C. 130 mm

D. 230 mm

What is the correct answer?

4

In a glass tube type water indicator for a boiler, one end of the tube is connected to water space and the other end is connected to

A. Water space also

B. Chimney

C. Steam space

D. Superheater

What is the correct answer?

4

The principal function of a stop valve is to

A. Control the flow of steam from the boiler to the main pipe and to shut off the steam completely when required

B. Empty the boiler when required and to discharge the mud, scale or sediments which are accumulated at the bottom of the boiler

C. Put off fire in the furnace of the boiler when the level of water in the boiler falls to an unsafe limit

D. Increase the temperature of saturated steam without raising its pressure