Related Questions
What is the correct answer?
4
Wavelength of radiation emitted by a body depends on the __________ of its surface.
What is the correct answer?
4
Increasing the carbon content of steel
A. Reduces the upper shelf energy
B. Increasing the ductility transition temperature
What is the correct answer?
4
Wave length of X-rays is about 1 angstrom; however it cannot pass through a sheet of
What is the correct answer?
4
A 2 kg object weighs 1.8 kgf on a spring balance. The value of 'g' at that location in m/sec2 is
What is the correct answer?
4
Closeness of packing is maximum in case of __________ crystal lattice.
What is the correct answer?
4
The approximate height of a blast furnace having a useful volume of 2000 m3 is about __________ metres
What is the correct answer?
4
Though tin occurs lower than iron in the electrochemical series, yet it is coated on steel for corrosion protection, because of its
C. Resistance to vegetable acids as the tin plate are commercially used in 'canning' industry
What is the correct answer?
4
The passage between the nozzle and the __________ is called 'sprue' in case of injection moulding.
What is the correct answer?
4
The underground well of a biogas plant is called the
What is the correct answer?
4
The two elements required to form substitutional solid solution should not have
A. Same crystalline structure
C. Widely differing electronegativity
What is the correct answer?
4
Pipelines carrying various utilities in chemical industries are identified by their colour codes. The color of pipeline carrying steam is
What is the correct answer?
4
Silicon percentage in silicon steel used for electrical equipments is about
What is the correct answer?
4
Corrosion is
D. An uncontrollable phenomenon
What is the correct answer?
4
Which of the following is a boiler accessory
i.e., not a boiler mounting?
What is the correct answer?
4
A cylindrical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is
What is the correct answer?
4
In troposphere (the weather domain), the temperature 't' at height 'h' above the sea level in metres is given by (where, temperature at sea level is 15°C and t is in °C.)
What is the correct answer?
4
The same volume of all gases is representative of their
C. Gas characteristic constants
What is the correct answer?
4
Out of the following, the joint produced by __________ has the lowest strength.
What is the correct answer?
4
A high pressure boiler generates steam at a pressure greater than __________ kg/cm2.
What is the correct answer?
4
Thermal equivalent of electrical power in practical calculation is __________ kcal/kWh.
What is the correct answer?
4
Recrystallisation temperature of steel is __________ °C.
What is the correct answer?
4
In a counter flow heat exchanger, hot fluid enters at 170°C & leaves at 150°C, while the cold fluid enters at 50°C & leaves at 70°C. The arithmetic mean temperature difference in this case is __________ °C.
What is the correct answer?
4
In an amorphous material, atoms defy any definite atomic structure and exist in random pattern just like in liquid. Which of the following is an amorphous material?
What is the correct answer?
4
The following type of bonding is strongly directional in solids.
What is the correct answer?
4
__________ is a special constituent of chlorophyll without which photosynthesis is not possible.
What is the correct answer?
4
The normal stress is the same in all directions at a point in a fluid, only when the fluid
A. Is at rest & has zero viscosity
C. Fluid layer has no motion relative to an adjacent layer of fluid
D. is incompressible & frictionless
What is the correct answer?
4
Electrochemical corrosion can occur, only if __________ is present in contact with metal.
What is the correct answer?
4
Normalising of an object does not
A. Refine coarse grain structure obtained during hot working
C. Improve yield strength
D. Improve mechanical properties
What is the correct answer?
4
A common disinfectant used in village wells for disinfection of water is
D. Potassium permanganate
What is the correct answer?
4
Pick out the correct statement.
A. Hot worked materials are subjected to annealing to remove internal stresses
B. Annealing of steel hardens it slightly
C. Normalising of a material induces stresses
D. Tempering of a material improves ductility & toughness but reduces hardness & brittleness