Home

Plastic flow in ductile materials

A. Increases the seriousness of static loading stress concentration

B. Lessens the seriousness of static loading stress concentration

C. Has no effect on it

D. Depends on other considerations

Related Questions

  1. A bolt of uniform strength can be developed by
  2. The period during which the cam follower remains at rest, when cam moves, is known as
  3. A steel containing 0.8% carbon is known as
  4. When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant…
  5. The toughness of a material _________ when it is heated
  6. A fast and loose pulley drive is used when
  7. A coupling used to connect two perfectly aligned shafts, is
  8. A tap bolt
  9. Which of the following statement is wrong?
  10. In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole…
  11. Which of the following is not correct procedure to increase the fatigue limit?
  12. The wire ropes make contact at
  13. A type of brake commonly used in motor cars is a
  14. For hardening alloy steels and high speed steels, they are heated to
  15. The pipe joint mostly used for pipes carrying water at low pressures is
  16. An alien bolt is
  17. According to I.B.R., when the thickness of the boiler shell (t) is less than 8 mm, then the diameter…
  18. The rolling contact bearings as compared to sliding contact bearings have
  19. Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d…
  20. Multiple threads are used to secure
  21. The constant factor in case of R10 series of preferred numbers is
  22. When two springs are in series (having stiffness K), the equivalent stiffness will be
  23. If the centre distance of the mating gears having involute teeth is varied within limits, the velocity…
  24. If T₁ and T₂ are the tensions on the tight and slack sides of the belt respectively, and…
  25. When the length of the journal is equal to the diameter of the journal, then the bearing is said to…
  26. A localised compressive stress at the area of contact between two members is known as
  27. In the levers of first type, the mechanical advantage is __________ one.
  28. The metal suitable for bearings subjected to heavy loads is
  29. For tight leakage joints, following type of thread is best suited
  30. The application of third type levers is found in

Please do not use chat terms. Example: avoid using "grt" instead of "great".