Refers to the outward-curving distortion of the lines of force near the edges of two parallel metal plates that form a capacitor.
Skin effect
Night effect
Edge effect
Hall effect
Correct Answer :
C. Edge effect
Related Questions
The ratio of maximum value to the effective value of an alternating quantity is called
Form factor
Peak factor
Dynamic factor
Leakage factor
Transient period is considered over after
What is the resonant frequency of a circuit when L of 25 microhenrys and C of 10 picofarads are in parallel?
10.1 kHz
10.1 MHz
101 MHz
101 kHz
A capacitance of 0.05 F equals
0.05 x 106F
0.05 x 10-6F
0.05 x 10-12F
0.05 x 1012F
In a rectangular wavea the form factor is
What is the peak factor for alternating current or voltage varying sinusiodally?
For a series circuita the higher the quality factor
The greater the bandwidth
The narrower the passband
The broader the resonance curve
The wider the passband
The capacitance of a capacitor is ___ relative permittivity.
Directly proportional to
Inversely proportional to
Equal to
Inversely proportional to the square of
A series-parallel combination of identical resistors will
Increase the power rating compared with one resistor alone
Increase the voltage rating compared with one resistor alone
Reduce the voltage rating compared with resistor alone
Result in an expensive circuit
Another term of the quality factor of the resonant circuit.
Figure of merit
Figure of demerit
Noise factor
Noise figure
The potential gradient in a cable is maximum in
Conductor
Outer sheath
Insulation
Uniformly all over
The open-circuit voltage at the terminal of load RL is 60V. Under the condition of maximum power transfera the load voltage will be
60 V
15 V
20 V
30 V
What refers to such work at very low temperaturesa near absolute zero?
Cryogenics
Superconductivity
Subsonic
Thermionic
Rationalizing the denominator of a complex number means
Eliminating the j component in the denominator
Adding j component in the denominator
Eliminating the j component in the numerator
Adding j component in the numerator
Refers to the outward-curving distortion of the lines of force near the edges of two parallel metal plates that form a capacitor.
Skin effect
Night effect
Edge effect
Hall effect
Metal tin becomes superconductor at approximately
6 K
3.7 K
5 K
4.7K
If three 9 mH inductors are connected in parallel without mutual inductance then the total i nductance is
3 mH
9 mH
27mH
18 mH
What is the purpose of a load in an electric circuit?
To increase the circuit current
To decrease the circuit current
To utilize electrical energy
To make the circuit complete
A trimmer is a variable capacitor in which capacitance is varied by changing the
Number of plates
Dielectric
Distance between plates
Plate area
Which component opposes voltage change?
Resistor
Inductor
Capacitor
Transistor
In a series RLCcircuit
Increasing the frequency decreases the resistance
Increasing the frequency increases the resistance
Both XLand XCchange as frequency changes
Impedance will always decrease
An inductor carries 2 A dc. If its inductance is 100 Ha then what is its inductive reactance?
Zero
1.3 k
In a pure capacitancea
Current leads voltage by 90�
Current leads voltage by 180�
Current lags voltage by 90�
Current lags voltage by 180�
An alloy composed of 84 % coppera 12 % manganese and 4 % nickel.
Manganin
Constantan
Nichrome
German silver wire
What is the specific resistance of a pure silicon?
55 -mm
55 -m
55 -cm
55 k -m
What fusion of elements is without chemical action between them?
Mixture
Compound
Alloy
Ionization
A capacitor is basically constructed of
Two conductors separated by a dielectric
Two dielectric separated by a conductor
Conductors and dielectric
Conductors and semiconductors
The resistance of an insulator ___ when its temperature is increased.
Decreases
Remains the same
Increases
Varies
When the movable plates of a gang capacitor completely overlap the fixed platesa the capacitance of the capacitor is
Halfway between maximum and minimum
Maximum
Minimum
Zero
Norton�s theorem is what form of an ac equivalent circuit?
Voltage
Current
Both voltage and current
Neither voltage nor current