Sacrificial anode method is used in the protection of pipelines which are buried underground. Sacrificial anode
Occurs higher in the electro-chemical series of metals
Is exemplified by magnesium plate
Is much cheaper than the cathodic base material to be guarded against corrosion
All (A), (B) & (C)
Also checkout these categories
Python Programming MCQ Clock MCQ Change of State MCQ Structural Organization In Animals MCQ Accounts Fundamental MCQ Direction MCQ Co-Ordination Compound MCQ Respiratory System MCQ Investment MCQ Fill in the blanks MCQ Mycoplasma and Bacteria MCQ Atomic Physics Theory MCQ
- Silicon percentage in acid resistant cast iron is about
- Large diameter reinforced cement concrete (RCC) pipes are generally joined by __________ joint.
- Which of the following test is used for distinguishing among dry oils, semi-drying oils and non drying…
- A fire tube boiler is limited to a maximum steam pressure of about __________ kg/cm2.
- Steel produced from phosphatic iron is __________ in nature.
- High relative humidity decreases the evaporative process and as the temperature is increased, the relative…
- Euler number is defined as the ratio of inertia force to __________ force.
- Cupola produces __________ iron.
- Thermistors are used in __________ devices.
- Oxide layer formed on the non-ferrous metal surface after its annealing is
- Between 230 and 370°C, blue brittleness is caused in mild steel because of the
- Fibre reinforced plastic (FRP) are
- Dryness fraction of dry steam is
- The co-ordination number in simple cubic structure is
- Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the
- Air/fuel ratio on molar (volume) basis for combustion of methane with theoretical quantity of air with…
- The same volume of all gases is representative of their
- In connection with corrosion of metals, passivation is the process that
- Viscoelastic behaviour is observed in __________ materials.
- Constituents of stellite are
- __________ property of steel increases by addition of large amount of silicon in it.
- Adhesives
- Glycerine is used as a coolant in cooling of some engines instead of water, because
- __________ of hard alloy and tool steel is done to make it easily machinable.
- Steel rods are normally used for concrete reinforcement because concrete and steel have almost equal
- Pick out the wrong statement about the machinability of metals. Machinability of a metal
- Load cells used for the measurement of weight has
- __________ joint is usually used for joining cast iron pipes mostly used for temporary pipelines, where…
- Aluminium is extracted from
- Heat release during phase change is observed in case of a/an