Related Questions
What is the correct answer?
4
The most suitable material of construction for a sewer to carry sewage under high pressure is
What is the correct answer?
4
A steam carrying pipeline is insulated with two layers of insulating materials with the inferior insulation material forming the inner part. If the two insulating layers are interchanged, the heat conducted will
D. May increase or decrease; depends on the thickness of each layer
What is the correct answer?
4
In the formation of cermets, the ratio of ceramic material to metallic material is usually 80:20. Which of the following is a cermet?
What is the correct answer?
4
Which of the following materials has the least scrap value?
What is the correct answer?
4
Unit of viscosity in CGS system is
What is the correct answer?
4
Consideration of the creep is the most important in case of the
B. Piston of an I. C. engine
C. Flywheel of steam engine
What is the correct answer?
4
Which of the following materials has the maximum shrinkage allowance?
What is the correct answer?
4
In a neutral solution
C. Both H+ and OH- ions are present in very small but equal concentration
What is the correct answer?
4
Liquor poisoning generally occurs due to the presence of __________ in it.
What is the correct answer?
4
Nusselt number/Biot number varies
A. Inversely with thermal conductivity
B. Directly with heat transfer co-efficient
C. Directly with thermal conductivity
D. Inversely with the dimension of the solid
What is the correct answer?
4
Faraday's law of electrolysis is related to the
B. Atomic number of the cation
C. Equivalent mass of the electrolyte
What is the correct answer?
4
Reynolds number of a fluid flowing in a circular pipe is 10,000. What will be the Reynolds number when the fluid velocity is decreased by 30% & the pipe diameter is increased by 30%?
What is the correct answer?
4
The kinematic viscosity (in stoke) and the absolute/dynamic viscosity (in poise) are the same for __________ at room temperature.
What is the correct answer?
4
Filler material used in welding should have __________ as compared to the parent metal to be welded.
A. Lower melting temperature
B. Same melting temperature
What is the correct answer?
4
Electrometallurgical methods of metal extraction is normally used for those metals
A. Whose oxide/ore is not reduced by carbon
B. Which fall in the category of alkali & alkaline earth metals
C. Which stands higher in the electrochemical series of the metal
What is the correct answer?
4
Between 230 and 370°C, blue brittleness is caused in mild steel because of the
A. Immobility of dislocation
C. Increase in Young's modulus
What is the correct answer?
4
Name the safety device used to protect the boiler, when the water level falls below a minimum level.
What is the correct answer?
4
Multistage compression of air as compared to single stage compression offers the advantage of
A. Power saving per unit weight of air delivered
B. Moisture elimination in the inter-stage cooler
C. Increased volumetric efficiency
What is the correct answer?
4
Normalising of an object does not
A. Refine coarse grain structure obtained during hot working
C. Improve yield strength
D. Improve mechanical properties
What is the correct answer?
4
Maraging steels derive their strength from the following mechanism:
A. A fine, highly dislocated and strong martensite
B. Fine dispersions of inter-metallic of Fe, Ni, Ti etc
C. Fine dispersions of alloy carbides in a ferrite matrix
D. Fine dispersions of C nucleated on dislocations in austenite
What is the correct answer?
4
A solar cell converts the sunlight directly into __________ energy.
What is the correct answer?
4
Exposure to __________ accelerates the degradation of plastics.
B. High atmospheric temperature
C. High ambient temperature
What is the correct answer?
4
Factor of safety is the ratio of the __________ stress to the working stress.
What is the correct answer?
4
The expected efficiency of a single riveted lap joint is of the order of 50%. If the thickness of the plate is increased four times, then the rivet diameter will have to be increased __________ times.
What is the correct answer?
4
Encyclopaedia of Chemical Technology has been
A. Authored by Kirk Othmer
B. Edited by Perry and Chilton
D. Authored by Perry and Chilton
What is the correct answer?
4
Which of the following is not a principal alloying element for the structural steel?
What is the correct answer?
4
Work study deals with the __________ study.
What is the correct answer?
4
The product (s) of roasting of a sulphide ore is (are)
D. Dependent on temperature and partial pressure of oxygen & sulphur dioxide
What is the correct answer?
4
In case of brasses, with decreasing zinc percentage and increasing copper percentage, its __________ increases.
What is the correct answer?
4
The activity co-efficient of the solute in a dilute solution
A. Decreases with the increase of concentration of the solute
B. Increases with the increase of concentration of the solute
D. Is unity at infinite dilution