Select the standard for token ring using token-passing media access.

Question

Select the standard for token ring using token-passing media access.

A. 802.2

B. 802.3

C. 802.5

Correct Answer :

C. 802.5

Share this question with your friends

Show all Networking MCQ

Comment

What is the code used for Interpret As Command (IAC)?

A. 253

B. 255

C. 240

D. 241

Discuss this answer

Where are routing tables placed?

Discuss this answer

Which of these is a feature of hubs?

Discuss this answer

What is the default port for Telnet?

A. 23

B. 21

C. 25

D. 80

Discuss this answer

Which cable type is immune to outside interference and crosstalk?

Discuss this answer

What is the maximum length of twisted-pair cable before a signal booster is needed? Select all that apply.

Discuss this answer

What is the maximum length of thinnet cable before a signal booster is needed?

D. 1 mile

Discuss this answer

What are the subnet mask in dotted decimal notation for /20 networks?

Discuss this answer

In distance vector routing an active router sends out information ………………………….

Discuss this answer

Following are the advantages of tree topology
i) Point-to-point wiring for individual segments.
ii) Supported by several hardware and software venders.
iii) Easy to install and wire

Discuss this answer

What does a patch cable connect to within an Ethernet network?

Discuss this answer

Which of the following protocols is described in RFC 793?

Discuss this answer

What is the distance limitation of Cat5 UTP?

A. 1 km

B. 100 km

C. 100 m

Discuss this answer

80 is the well-known port number for the HTTP service.

A. True.

B. False.

Discuss this answer

Which of the following application uses 1.5 Mbps bandwidth?

Discuss this answer

What can be used in the place of DNS to resolve host names to IP addresses?

A. WINS

C. Hosts

D. DHCP

Discuss this answer

The Point-to-Point Protocol (PPP) is described in which of the following?

Discuss this answer

You've taken your Windows 2000 laptop to a client's network and plugged it in. Your computer is configured for an IP network over 100BaseT using DHCP. You can't connect, even though the client says that DHCP is working on his 100BaseT network. What should

Discuss this answer

Which of the following protocol was developed to overcome limitations of Routing
Information Protocol (RIP)?

Discuss this answer

Network administrator checks whether all the devices connected to the end-to-end path
are _________-enabled.

Discuss this answer

Router B receives an update from router A that indicates Net1 is two hops away. The next update from A says Net1 is five hops away. What value is entered in B's routing table for Net1? Assume the basic RIP is being used.

A. 6

B. 7

C. 2

D. 3

Discuss this answer

What can be used in the place of DNS to resolve host names to IP addresses?

A. WINS

C. Hosts

D. DHCP

Discuss this answer

You're configuring a dial-up connection to an ISP. Which of the following protocols is used?

A. PPTP

B. PPP

C. VPN

D. IPSec

Discuss this answer

Which layer of the OSI model does a switch operate in?

Discuss this answer

What is the maximum size of IP header in the UDP Datagram format?

Discuss this answer

Which function is not supported by E-mail?

Discuss this answer

Which of the following is the port used by SMTP?

A. 21

B. 23

C. 25

D. 80

Discuss this answer

Which of the following is currently a de facto standard, commonly used for point-to-point
serial connections running TCP/IP?

Discuss this answer

Strings enclosed in _______ quotation marks indicate single tokens.

C. ASCII

D. Binary

Discuss this answer

Which of the following pieces of equipment will receive a packet from one port and forward that packet out the one port to which the destination computer is connected?

A. Hub

B. MAU

C. Switch

D. TDR

Discuss this answer

Answer 1

D. 802.11(b)

Answer 2

A. in network interface card

Answer 3

B. in routers memory

Answer 4

C. in server memory

Answer 5

D. in a subnets memory

Answer 6

A. Hubs amplify the incoming signal.

Answer 7

B. Hubs understand frames, packets or headers

Answer 8

C. All lines coming into a Hub must operate at a same speed.

Answer 9

D. all of these

Answer 10

A. Thinnet

Answer 11

B. Thicknet

Answer 12

C. Twisted pair

Answer 13

D. Fiber optic

Answer 14

A. 25 meters

Answer 15

B. 100 meters

Answer 16

C. 328 feet

Answer 17

D. 1000 feet

Answer 18

A. 185 meters

Answer 19

B. 500 feet

Answer 20

C. 1600 feet

Answer 21

A. 255.255.252.0

Answer 22

B. 255.255.255.0

Answer 23

C. 255.255.254.0

Answer 24

D. 255.255.240.0

Answer 25

A. Only when there is a change in its table

Answer 26

B. Only when a new host is added

Answer 27

C. At regularly scheduled intervals

Answer 28

D. Only when a new network is added

Answer 29

A. i) only

Answer 30

B. i) and ii) only

Answer 31

C. iii) only

Answer 32

D. i) ,ii) and iii)

Answer 33

A. The patch panel to the hub

Answer 34

B. The patch panel to the wall jack

Answer 35

C. The wall jack to the computer

Answer 36

D. The NIC directly to another computer's NIC

Answer 37

A. Address Resolution Protocol (ARP)

Answer 38

B. Transmission Control Protocol (TCP)

Answer 39

C. Bootstrap Protocol (BOOTP)

Answer 40

D. User Datagram Protocol (UDP)

Answer 41

D. 100 foot

Answer 42

A. High speed internet browsing

Answer 43

B. Recording for later viewing

Answer 44

C. Two(2)other TV'S

Answer 45

D. One(1)high definition TV(HDTV)

Answer 46

B. LMHosts

Answer 47

A. RFC 3390 AND RFC 3392

Answer 48

B. RFC 1661 AND RFC 1662

Answer 49

C. RFC 2490 AND RFC 2492

Answer 50

D. RFC 2225 AND RFC 2226

Answer 51

A. Use Ipconfig /release to release the old DHCP address.

Answer 52

B. Use Winipcfg and click Release to release the old DHCP address.

Answer 53

C. Use Ifconfig to initialize the NIC.

Answer 54

D. Use Tracert to determine the problem.

Answer 55

A. Border Gateway Protocol (BGP)

Answer 56

B. Exterior Gateway Protocol (EGP)

Answer 57

C. Enhanced Interior Gateway Routing Protocol (EIGRP)

Answer 58

D. Open Shortest Path First (OSPF)

Answer 59

A. Any cast

Answer 60

B. Broadcast

Answer 61

C. Unicast

Answer 62

D. Multicast

Answer 63

B. LMHosts

Answer 64

A. Physical

Answer 65

B. Data-link

Answer 66

C. Network

Answer 67

D. Transport

Answer 68

A. 40 bytes

Answer 69

B. 50 bytes

Answer 70

C. 60 bytes

Answer 71

D. 70 bytes

Answer 72

A. authentication

Answer 73

B. composition

Answer 74

C. Disposition

Answer 75

D. Displaying

Answer 76

A. Fiber Distributed Data Interface (FDDI)

Answer 77

B. Serial Line IP (SLIP)

Answer 78

C. Point-to-Point Protocol (PPP)

Answer 79

D. IEEE 802.3

Answer 80

A. Alphanumeric

Answer 81

B. Morse code

Select the standard for token ring using token-passing media access.

Correct Answer :

Show all Networking MCQ

Related Questions

What is the code used for Interpret As Command (IAC)?

Where are routing tables placed?

Which of these is a feature of hubs?

What is the default port for Telnet?

Which cable type is immune to outside interference and crosstalk?

What is the maximum length of twisted-pair cable before a signal booster is needed? Select all that apply.

What is the maximum length of thinnet cable before a signal booster is needed?

What are the subnet mask in dotted decimal notation for /20 networks?

In distance vector routing an active router sends out information ………………………….

Following are the advantages of tree topology
i) Point-to-point wiring for individual segments.
ii) Supported by several hardware and software venders.
iii) Easy to install and wire

What does a patch cable connect to within an Ethernet network?

Which of the following protocols is described in RFC 793?

What is the distance limitation of Cat5 UTP?

80 is the well-known port number for the HTTP service.

Which of the following application uses 1.5 Mbps bandwidth?

What can be used in the place of DNS to resolve host names to IP addresses?

The Point-to-Point Protocol (PPP) is described in which of the following?

You've taken your Windows 2000 laptop to a client's network and plugged it in. Your computer is configured for an IP network over 100BaseT using DHCP. You can't connect, even though the client says that DHCP is working on his 100BaseT network. What should

Which of the following protocol was developed to overcome limitations of Routing
Information Protocol (RIP)?

Network administrator checks whether all the devices connected to the end-to-end path
are _________-enabled.

Router B receives an update from router A that indicates Net1 is two hops away. The next update from A says Net1 is five hops away. What value is entered in B's routing table for Net1? Assume the basic RIP is being used.

What can be used in the place of DNS to resolve host names to IP addresses?

You're configuring a dial-up connection to an ISP. Which of the following protocols is used?

Which layer of the OSI model does a switch operate in?

What is the maximum size of IP header in the UDP Datagram format?

Which function is not supported by E-mail?

Which of the following is the port used by SMTP?

Which of the following is currently a de facto standard, commonly used for point-to-point
serial connections running TCP/IP?

Strings enclosed in _______ quotation marks indicate single tokens.

Which of the following pieces of equipment will receive a packet from one port and forward that packet out the one port to which the destination computer is connected?

Also checkout

Select the standard for token ring using token-passing media access.

Correct Answer :

Show all Networking MCQ

Related Questions

What is the code used for Interpret As Command (IAC)?

Where are routing tables placed?

Which of these is a feature of hubs?

What is the default port for Telnet?

Which cable type is immune to outside interference and crosstalk?

What is the maximum length of twisted-pair cable before a signal booster is needed? Select all that apply.

What is the maximum length of thinnet cable before a signal booster is needed?

What are the subnet mask in dotted decimal notation for /20 networks?

In distance vector routing an active router sends out information ………………………….

Following are the advantages of tree topologyi) Point-to-point wiring for individual segments.ii) Supported by several hardware and software venders.iii) Easy to install and wire

What does a patch cable connect to within an Ethernet network?

Which of the following protocols is described in RFC 793?

What is the distance limitation of Cat5 UTP?

80 is the well-known port number for the HTTP service.

Which of the following application uses 1.5 Mbps bandwidth?

What can be used in the place of DNS to resolve host names to IP addresses?

The Point-to-Point Protocol (PPP) is described in which of the following?

You've taken your Windows 2000 laptop to a client's network and plugged it in. Your computer is configured for an IP network over 100BaseT using DHCP. You can't connect, even though the client says that DHCP is working on his 100BaseT network. What should

Which of the following protocol was developed to overcome limitations of Routing Information Protocol (RIP)?

Network administrator checks whether all the devices connected to the end-to-end path are _________-enabled.

Router B receives an update from router A that indicates Net1 is two hops away. The next update from A says Net1 is five hops away. What value is entered in B's routing table for Net1? Assume the basic RIP is being used.

What can be used in the place of DNS to resolve host names to IP addresses?

You're configuring a dial-up connection to an ISP. Which of the following protocols is used?

Which layer of the OSI model does a switch operate in?

What is the maximum size of IP header in the UDP Datagram format?

Which function is not supported by E-mail?

Which of the following is the port used by SMTP?

Which of the following is currently a de facto standard, commonly used for point-to-point serial connections running TCP/IP?

Strings enclosed in _______ quotation marks indicate single tokens.

Which of the following pieces of equipment will receive a packet from one port and forward that packet out the one port to which the destination computer is connected?

Also checkout

Following are the advantages of tree topology
i) Point-to-point wiring for individual segments.
ii) Supported by several hardware and software venders.
iii) Easy to install and wire

Which of the following protocol was developed to overcome limitations of Routing
Information Protocol (RIP)?

Network administrator checks whether all the devices connected to the end-to-end path
are _________-enabled.

Which of the following is currently a de facto standard, commonly used for point-to-point
serial connections running TCP/IP?