Related Questions
What is the correct answer?
4
Points to be considered in choosing a capacitor
What is the correct answer?
4
A law which states that when a constant electromotive force is applied to a circuit consisting of a resistor and capacitor connected in seriesa the time taken for the potential on the plates of the capacitor to rise to any given fraction of its final value depends only on the product of capacitance and resistance.
What is the correct answer?
4
The rms value of a triangular or sawtooth waveform is ___ tim value.
What is the correct answer?
4
A capacitor requires 12 C of charge to raise its potential of 3 V. What is the capacitance of the capacitor?
What is the correct answer?
4
A series RLCcircuit has a ______ power factor at its half-power points
What is the correct answer?
4
What is the conductance of a circuit having three 10 resistors in parallel?
What is the correct answer?
4
What is the total resistance of a two equal valued resistors in series?
A. The difference of both
D. The sum of their reciprocals
What is the correct answer?
4
In a series RLCcircuit
A. The current lags VLby 90�
B. The current leads VLby 90�
What is the correct answer?
4
Which of the following is a disadvantage of a wire-wound resistor?
A. It has reactance in radio-frequency circuits
B. It cannot handle much power
C. It draws a large amount of current
D. It cannot handle high voltage
What is the correct answer?
4
When current and voltage arte in phase in an ac circuita the ___ is equal to zero.
What is the correct answer?
4
Which is considered as the effect of a dielectric material?
A. Increasing capacitance
B. Decreasing capacitance
C. Reducing the working voltage
D. Increasing the distance between the plates
What is the correct answer?
4
If two complex conjugates are addeda ___ components results.
What is the correct answer?
4
For a series circuita the higher the quality factor
A. The greater the bandwidth
B. The narrower the passband
C. The broader the resonance curve
D. The wider the passband
What is the correct answer?
4
At what frequency will an inductor of 5mH have the same reactance as a capacitor of 0.1 F?
What is the correct answer?
4
Which of the following is not considered a physical factor affecting resistance?
What is the correct answer?
4
The internal resistance of an ideal current source is
C. Equal to the load resistance
What is the correct answer?
4
In a multiple capacitora the plate area is
What is the correct answer?
4
The charging of a capacitor through a resistance follows what law?
What is the correct answer?
4
The usual load of a dc circuit is a/an
D. Both inductor and capacitor
What is the correct answer?
4
When two in-phase sine waves that have identical frequency and amplitude are added togethera then the result is a sine wave with ___ the amplitude of either.
What is the correct answer?
4
Which of the following is not a factor affecting dielectric strength?
What is the correct answer?
4
If one resistance in a series connection is opena then
A. The current is zero in all the other resistances
B. The current is maximum in all the other resistances
C. The voltage is zero across the open resistance
D. The voltage is infinite across the open resistance
What is the correct answer?
4
Which of the following conditions is not true for a series RLCcircuit at resonance?
C. The power factor is one
What is the correct answer?
4
The factor 0.707for converting peak to rms applies only to
What is the correct answer?
4
The admittance of a parallel RLC circuit is found to be the ___ sum of conductance and susceptances.
What is the correct answer?
4
A linear circuit is one whose parameters
A. Change with change in voltage
B. Change with change in current
C. Do not change with voltage and current
D. Change with change in voltage and current
What is the correct answer?
4
What is the resonant frequency of a circuit when L of 3 microhenrys and C of 40 picofarads are in series?
What is the correct answer?
4
In dividing or multiplying phasor quantitiesa ___ form is used.
What is the correct answer?
4
As applied to a series RLCcircuita bandwidth means
A. The frequency range for maximum power transfer
B. The difference between the highest and lowest frequencies of the oscillator
C. The separation of the half-power points
D. The frequency at which XL= XC
What is the correct answer?
4
An open resistor when checked with an ohmmeter reads
C. High but within the tolerance