Silicon percentage in silicon steel used for electrical equipments is about
1
4.0
8
14
Correct Answer :
B. 4.0
Related Questions
In a neutral solution
H+ ions are absent
OH- ions are absent
Both H+ and OH- ions are present in very small but equal concentration
None of these
__________ joint is usually used for joining cast iron pipes mostly used for temporary pipelines, where it may be necessary to dismantle & reassemble the pipeline very frequently.
Collar
Flanged
Bell and Spigot
Expansion
An abrupt and sudden fall in the reading of barometer is an indication of the
Storm
Rain
Clear weather
Cold wave
Brazing filler metal used for joining steel plates
Melts below the melting points of base metals
Melts below 300°C
Is copper phosphorous alloy
Is copper
Vibration upto 100 kilo hertz can be most accurately measured by a __________ type accelerometer.
Preloaded spring
Piezoelectric
Bonded strain gauge
None of these
The cathode in an electrochemical cell always carries
Negative charge
Positive charge
Zero charge
Positive or negative charge depending upon the nature of the cell
The amount of water evaporated in kg per kg of fuel burnt in a boiler is called the __________ of a boiler.
Evaporative capacity
Evaporation efficiency
Thermal efficiency
Steam load
Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the
Length of the pipe
Diameter of the pipe
Density of the fluid
Velocity of the fluid
The same volume of all gases is representative of their
Specific gravities
Densities
Gas characteristic constants
Molecular weights
Which of the following is resistant to the action of both heat & chemicals?
Borosilicate glass
Silica glass
Soda lime glass
None of these
Breakeven point represents the condition, when the company runs under no profit no loss condition. In break even analysis, total cost comprises of fixed cost
Only
Plus variable cost
Plus overhead cost
Plus selling expenses
Plastics as a material of construction suffer from the drawback of low
Machinability
Density
Strength
Plastic deformation
Steel rods are normally used for concrete reinforcement because concrete and steel have almost equal
Tensile strength
Compressive strength
Young's modulus
Thermal co-efficient of expansion
The effect of friction on the flow of steam through a nozzle is to decrease the __________ of steam.
Wetness
Mass flow rate
Both 'a' & 'b'
Neither 'a' nor 'b'
Coarse grained steels have
Low toughness
No tendency to distort
High density
Very high toughness
__________ rubber is generally used for making 'O' rings used for vacuum sealings.
Natural
Neoprene
Butadiene
Nitrile
A dummy activity is used in PERT network to describe the
Precedence relationship
Resource idleness
Resource restriction
Necessary time delay
The best guide to judge the general quality of water is the measurement of its
pH value
Electrical conductivity
Turbidity
Dissolved oxygen content
The product (s) of roasting of a sulphide ore is (are)
Oxide only
Sulphate only
Oxide and sulphate
Dependent on temperature and partial pressure of oxygen & sulphur dioxide
Flue gases pass through the following boiler accessories in a high pressure natural circulation boiler.
A. Induced draft fan
B. Economiser
C. Air preheater
D. Steam superheater Which of the following gives the correct sequence of flow of the flue gases through the above mentioned boiler accessories?
A, C, B, D
D, B, C, A
D, C, B, A
D, A, B, C
The main charge in blast furnace is usually
Iron ore & coke
Iron ore, coke & air
Limestone, coke & iron ore
Limestone, sand & iron ore
Basicity 
of the slag in Indian blast furnace is in the range of
0.7-1.0
1.1-1.4
1.5 - 1.8
2.0 - 2.5
Constituents of stellite are
Zinc, copper & nickel
Cobalt, chromium & tungsten
Zinc, aluminium & nickel
Nickel, cobalt & vanadium
Cast iron contains __________ percent carbon.
2.5
3.75
4.75
5.25
For a thermodynamic system undergoing a process, which of the following pairs best expresses the relationship similar to that expressed by the pressure volume plot?
Temperature - entropy
Temperature - pressure
Enthalpy - entropy
Enthalpy-pressure
The lightest non-inflammable gas is
H2
He
Ar
O2
'Ice point' is designated on Fahrenheit temperature scale by
0°
32°
62°
212°
Increase in temperature, in general results in the
Decrease in the viscosities of both liquids & gases
Increase in the viscosities of both liquids & gases
Increase in the viscosity of liquids and decrease in that of gases
Decrease in the viscosity of liquids and increase in that of gases
Volumetric composition of flue gas analysed with the Orsat apparatus is : CO2 = 12%, O2 = 8%, CO = nil, N2 = 80%. This flue gas composition indicates that
Pure oxygen has been used for combustion
Nitrogen percentage in the fuel is very high
Excess air has been used for combustion
Hydrogen is not present in the fuel
Regeneration of molecular sieve requires it to be heated to a temperature of about __________ °C.
80-120
200-300
600-800
1000-1100