Related Questions
What is the correct answer?
4
The most suitable material of construction for a sewer to carry sewage under high pressure is
What is the correct answer?
4
With increase in annealing temperature, the following defect density decreases.
What is the correct answer?
4
Age hardening is connected with
What is the correct answer?
4
Maximum amount of thermal radiation is emitted at all wavelengths at any specified temperature by a/an __________ body.
What is the correct answer?
4
Tip of the match stick contains a mixture of
What is the correct answer?
4
Cold cracking in the heat affected zone of a high strength steel weld can take place because of the
C. Relatively high sulphur content in the base metal
D. Sufficient hydrogen present in the welding arc
What is the correct answer?
4
Fatigue resistance of a material is measured by the
B. Ultimate tensile strength
What is the correct answer?
4
The amount of water evaporated in kg per kg of fuel burnt in a boiler is called the __________ of a boiler.
B. Evaporation efficiency
What is the correct answer?
4
Temperature profile along the length of a gasgas counter flow heat exchanger is correctly represented by
What is the correct answer?
4
In TIG welding, thoriated tungsten electrodes are used, because it
A. Has higher current carrying capacity
B. Has better electron emissivity
C. Is stronger than ordinary tungsten
What is the correct answer?
4
Specific __________ is a dimensionless quantity.
What is the correct answer?
4
Coating provided on the electrodes used in the arc welding is not expected to
B. Prevent electrode from contamination
D. Provide protective atmosphere to weld
What is the correct answer?
4
Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect of free convection over a vertical flat plate as
What is the correct answer?
4
With decrease in the grain size of a material, its creep resistance
D. Either (A) or (B); depends on the material
What is the correct answer?
4
The emf of a Deniell cell Zn | Zn2+ || Cu2+ | Cu can be increased by
A. Decreasing the surface area of the electrodes
B. Increasing the concentration of zinc sulphate solution
C. Increasing the surface area of the electrodes
D. Increasing the concentration of copper sulphate solution
What is the correct answer?
4
Which of the following is not used as a bearing material?
What is the correct answer?
4
Natural water contains approximately __________ percent of heavy water.
What is the correct answer?
4
The bolt is subjected to __________ when the nut is tightened by putting the washer beneath it.
What is the correct answer?
4
If the demand for an item is trebled and the order cost is reduced to one third, then the economic order quantity
C. Decreases by a factor of 3
D. Decreases by a factor of 1/3
What is the correct answer?
4
Maraging steels derive their strength from the following mechanism:
A. A fine, highly dislocated and strong martensite
B. Fine dispersions of inter-metallic of Fe, Ni, Ti etc
C. Fine dispersions of alloy carbides in a ferrite matrix
D. Fine dispersions of C nucleated on dislocations in austenite
What is the correct answer?
4
Non-ferrous alloys used for making cutting tools need not have high
What is the correct answer?
4
The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
What is the correct answer?
4
Density in the solid state is slightly less than that in its liquid state, in case of
What is the correct answer?
4
__________ property of steel increases by addition of large amount of silicon in it.
What is the correct answer?
4
Though tin occurs lower than iron in the electrochemical series, yet it is coated on steel for corrosion protection, because of its
C. Resistance to vegetable acids as the tin plate are commercially used in 'canning' industry
What is the correct answer?
4
__________ temperature remains constant during adiabatic saturation process of unsaturated air.
What is the correct answer?
4
Ferromagnetic materials owe their properties to __________ inner sub-shells.
What is the correct answer?
4
The kinematic viscosity (in stoke) and the absolute/dynamic viscosity (in poise) are the same for __________ at room temperature.
What is the correct answer?
4
Which of the following is not a ferromagnetic material?
What is the correct answer?
4
In connection with corrosion of metals, passivation is the process that
A. Intensifies deterioration
B. Changes the composition of the metal
C. Inhibits further deterioration