Home

Specific gravity of hot metal (pig iron) is __________ times that of the blast furnace slag.

A. 2

B. 3

C. 0.8

D. 6

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The majority charge carriers in p-type silicon are
  2. The most detrimental impurity in high pressure boiler feed water is
  3. A material being tested for endurance strength is subjected to the __________ load.
  4. Limestone addition in the blast furnace is done to flux __________ present in the raw materials.
  5. For a small scale toy factory, the fixed cost per month is Rs. 5000/-. The variable cost per toy is…
  6. What is the range of tempering temperature (°C) for most of the materials?
  7. The elastic strain in copper is due to the
  8. Identify the correct statement with reference to the extractive metallurgy of aluminium.
  9. Cemented carbide tools are not suitable for cutting
  10. Which of the following is the most wear resistant grade of carbide used for the cutting tools?
  11. The amount of water evaporated in kg per kg of fuel burnt in a boiler is called the __________ of a…
  12. Which of the following is used to produce draught in the locomotive boilers?
  13. Two solutions A1 & A2 have pH value of 2 & 6 respectively. It implies that the solution
  14. Thermodynamic cycle involved in the working of a thermal power plant is the __________ cycle.
  15. The fugacity of liquid water at 298 K is approximately 3171 Pa. Considering the ideal heat of vaporisation…
  16. Yield strength of a polycrystalline metal with an average grain size d, is proportional to
  17. Pick out the wrong statement.
  18. Thermal efficiency of an internal combustion engine is around __________ percent.
  19. The co-ordination number in simple cubic structure is
  20. __________ flux is used for the extraction of metal from its self fluxing ores.
  21. __________ joint is mostly used for joining pipes carrying water at low pressure.
  22. Which of the following are made out of the carbon steel having carbon content of 0.9 to 1%?
  23. The following type of bonding is strongly directional in solids.
  24. Which of the following terminology is used for the temperature at which new grains are formed in a metal?
  25. A fire tube boiler is limited to a maximum steam pressure of about __________ kg/cm2.
  26. In the X-ray radiography technique, the tube voltage for thicker plates as compared to thin plates,…
  27. Globular form of cementite is formed during the __________ process.
  28. The usual energy consumption in electric arc furnace steel making is __________ KWh/ton of steel.
  29. The mechanism involved in the removal of metal in drilling operation is by
  30. Which of the following pairs is not correctly matched?