Square steel key is normally strong in failure by shear & crushing. Keys are normally made of __________ steel bars.
Hot rolled mild
Cold rolled mild
Forged
Machinable stainless
Also checkout these categories
Analogy MCQ Fungi and Lichens MCQ Phylum - Amphibia MCQ Computer Architecture MCQ Design of Masonry Structures MCQ Wave, Motion, and Sound MCQ Solids, Liquides, Gases MCQ Indirect TAX MCQ Machine Design MCQ Microsoft Access MCQ Heat & Mass Transfer MCQ Skin Anatomy and Physiology MCQ
- Which of the following is the most suitable material of construction for the condenser tubes, where…
- Diameter of the rivet to be provided on a 20 mm. thick boiler plate will be __________ mm.
- Pick out the wrong statement.
- Silicon percentage in the silicon steel used for electrical appliances/equipments is
- Gantt charts are used for streamlining the
- The main constituent of bones is
- With increase in steam pressure, its specific volume decreases
- Propulsion of rocket follows from the
- In a good rimming steel
- Which of the following material handling equipments is not suitable for moving materials in varying…
- Which of the following metals is not subjected to electrolytic refining/purification?
- Materials having resistivity ranging from 1 to 100 ohm. cm is termed as
- In inventory control theory, the economic order quantity (EOQ) is the
- The condition of diffraction from a crystal is given by
- Common salt is produced from sea water in India generally by the __________ method.
- Brinell Hardness Number (BHN) for talc is approximately in the range of
- The malleability of a material is the property by virtue of which it can be rolled or hammered into…
- With increase in __________ Knocking tendency in a spark ignition petrol engine decreases.
- Which of the following phenomenon/ phenomena is/are diffusion controlled?
- __________ furnace is generally used in the non-ferrous foundries.
- Magnetic permeability of iron is increased by its
- __________ rubber is generally used for making 'O' rings used for vacuum sealings.
- Consideration of the creep is the most important in case of the
- __________ has a negative co-efficient of linear expansion.
- Joining of thin foils is preferred to be done by
- Addition of __________ to steel does not impart hardness.
- Hardening of steel is not possible, unless it is heated __________ critical point.
- Corrosion of metals cannot be prevented by its
- The most important consideration, while designing the refrigeration system of an aircraft is that the…
- In Newton's law of viscosity, which states that the shear stress is proportional to the __________ Co-efficient…