Home

Steam condenser tubes are made of admiralty brass, in which percentage of zinc & copper are __________ respectively.

A. 70 & 30

B. 30 & 70

C. 50 & 50

D. 90 & 10

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Latent heat of dry steam at atmospheric pressure is 539 Kcal/kg; which __________ with increase in the…
  2. Non-ferrous alloys used for making cutting tools need not have high
  3. Capacity & power requirement for an air compressor working at high altitude compared to sealevel will…
  4. Carnot cycle is also termed as the constant __________ cycle in thermodynamics.
  5. At 100% relative humidity, the dew point temperature of moist air is
  6. When dry bulb temperature & wet bulb temperature of moist air is the same, it means that the
  7. Resilience of a bolt can be increased by increasing its
  8. The minimum and the maximum number of members required to form a Private Limited Joint Stock Company…
  9. Yield strength of a polycrystalline metal with an average grain size d, is proportional to
  10. Catalyst used in the 'catalytic converter' employed in automobile exhaust line for complete combustion/oxidation…
  11. Case hardening is not done by
  12. Maximum consumption of limestone is in the __________ industry.
  13. Enzymes belong to the category of
  14. The dimensional formula of bulk modulus of elasticity is same as that of the
  15. The efficiency of a Carnot heat engine operating between absolute temperatures T1 and T2 (when, T1 >…
  16. M10 index of coke indicates its
  17. As the fluid flow rate increases, the float of the Rotameter
  18. Isotropic materials have the same __________ in all directions.
  19. Hydro-cyclone is a
  20. Thermal conductivity of a material does not depend upon its
  21. Vernier calipers cannot be used to measure the
  22. Cassiterite is an ore of
  23. Dislocation cross-slip is difficult in those materials, which have
  24. Coating provided on the electrodes used in the arc welding is not expected to
  25. Recrystallisation temperature of steel is __________ °C.
  26. Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel &…
  27. In a furnace with heating element temperature at 1700°C, the dominant mechanism of heat transfer…
  28. Which of the following does not discharge the dust collected as a dry solid?
  29. The amount of water evaporated in kg per kg of fuel burnt in a boiler is called the __________ of a…
  30. For dynamic strain measurement, the Wheatstone bridge used is of __________ type.