Home
PDF Store
Exams
G.K.
Aptitude
Reasoning
English
Computer
Biology
Privacy
About
Contact
Home
All MCQ
Exams
PDF Store
G.K.
Aptitude
Reasoning
English
Computer
Biology
Privacy
About
Contact
What is the correct answer?
4
Steel is welded using the __________ flame.
A.
Carburising
B.
Neutral
C.
Oxidising
D.
All (A), (B) & (C)
Correct Answer :
B. Neutral
Related Questions
Which of the following materials has the maximum shrinkage allowance?
Which of the following is not used as a bearing material?
During sensible cooling of air, its wet bulb temperature
The lightest non-inflammable gas is
The maximum thickness of the metal which can be welded using ultrasonic…
While the recrystallisation temperature for pure metals is 0.3 Tm, the…
In case of compression of one kg of air, the work done will be the least,…
The most prominent single cause of corrosion in boiler-tubes, drums, economisers…
Yield strength of a material is determined by the __________ test.
According to maximum shear stress failure criterion, yielding in material…
A solar cell converts the sunlight directly into __________ energy.
Which of the following is resistant to the action of both heat & chemicals?
In an amorphous material, atoms defy any definite atomic structure and…
'Flare tower' used in industry is meant for
Maximum permissible sulphur content in steel is __________ percent.
Addition of __________ to steel does not impart hardness.
The best guide to judge the general quality of water is the measurement…
Stainless steel is welded using
Latent heat of dry steam at atmospheric pressure is 539 Kcal/kg; which…
Diffusion co-efficient of a metal in a solid solution depends upon its
Which of the following is not a characteristic observed in material failure…
Density in the solid state is slightly less than that in its liquid state,…
Out of the following, maximum temperature drop for a given heat flow &…
In Newton's law of viscosity, which states that the shear stress is proportional…
Lead is poured into the joints between two __________ pipes.
Which of the following alloying elements is present in maximum percentage…
Which of the following metals reacts violently with water?
Cold chisels hammers are made of
Which of the following materials has the poorest electrical conductivity?
Triple point of water is
Also checkout
s-Block Element MCQ
Machine Input Mi-set 2 MCQ
Sitting Arrangement MCQ
Computer Architecture MCQ
Human reproductive system MCQ
Geography MCQ
Chemical Engineering Thermodynamics MCQ
IBPS Common Written Exam (PO/MT) Main 2016 Solved Paper MCQ
Operating System MCQ
Decimal Fraction MCQ
Respiratory System MCQ
Aldehydes and Ketones MCQ