__________ stress cannot be sustained by a fluid in equilibrium.

A. Shear

B. Tensile

C. Compressive

D. None of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Solute atoms which cause yield point phenomenon in mild steel are/is
  2. The heat released by cooling one mole of copper from 400 K to room temperature (300 K) is (assume :…
  3. The 'laughing gas' is
  4. One of the methods of purification of leach liquor is ion exchange, which involves
  5. The capacity of a spring to store energy is called the spring form co-efficient. Stiffness of a spring…
  6. The function of neutral flux used in the pyrometallurgy of metal extraction is to increase the __________…
  7. Eutectoid composition of carbon steel at room temperature is
  8. Holes for riveting purposes should be preferably made by
  9. Temper brittleness of a material can be fairly detected by the __________ test.
  10. The condition of diffraction from a crystal is given by
  11. Euler number is defined as the ratio of inertia force to __________ force.
  12. A thin, flat & square plate measuring 2 m × 2 m is freely hanging in ambient air at 25°C.…
  13. Projection welding & stud welding is categorised as the __________ welding.
  14. The delivery pressure of boiler feed water pump compared to the boiler steam pressure is
  15. The most prominent single cause of corrosion in boiler-tubes, drums, economisers and steam superheaters…
  16. Wrought iron is not
  17. Function of gear box is to
  18. Satellites burn off during re-entry to earth's atmosphere, because of the
  19. While the bin cards are used in the effective stores management, the queuing theory is associated with…
  20. Hot extrusion of aluminium is done in the temperature range of __________ °C.
  21. Drossing is a __________ operation.
  22. The maximum stress below which a material can withstand an infinite number of cycle of stress, is termed…
  23. Fog is an example of colloidal system of
  24. The activity co-efficient of the solute in a dilute solution
  25. The majority charge carriers in p-type silicon are
  26. Otto cycle used in spark ignition petrol engines is also known as the constant __________ cycle.
  27. Atomic __________ of an element is a whole number.
  28. The most serious manufacturing defect from fracture toughness point of view is
  29. Factor of safety in machine design is defined as the ratio of ultimate stress to __________ stress.
  30. Which of the following processes follows the hardening process for reducing the hardening strains &…