Related Questions
What is the correct answer?
4
What is the range of tempering temperature (°C) for most of the materials?
What is the correct answer?
4
at 1173E; at equilibrium, what will be the number of moles of CO gas required to reduce one mole of at 1173 K?
What is the correct answer?
4
A fluid is termed as the Newtonian fluid, when the shear stress is __________ the velocity gradient.
B. Inversely proportional to
C. Directly proportional to
What is the correct answer?
4
Work done by a/an __________ process is determined by ∫p. dv
What is the correct answer?
4
At absolute zero temperature, for any reaction involving condensed phases
What is the correct answer?
4
Out of the following, the joint produced by __________ has the lowest strength.
What is the correct answer?
4
Wrought iron is never shaped by
What is the correct answer?
4
Gross national product (GNP) means the total value of __________ in a country.
C. Earning of the citizens
What is the correct answer?
4
The same volume of all gases is representative of their
C. Gas characteristic constants
What is the correct answer?
4
Resistance of an electrical conductor is proportional to its (where, l = length and A = cross-sectional area of the conductor)
What is the correct answer?
4
The temperature at which the magnetic property of iron disappears (i.e., it becomes non-magnetic) and its electrical conductivity & specific heat also changes, is called the 'Curie point', which is __________ °C.
What is the correct answer?
4
Electrometallurgy is not involved in the extraction of __________ from its ore.
What is the correct answer?
4
Out of the following, the best material capable of withstanding shock & vibration without the danger of cracking is
What is the correct answer?
4
__________ pipe is the most suitable for carrying sanitary drainage.
B. Reinforced cement concrete
What is the correct answer?
4
Babbitt lining is used on brass/bronze bearings to increase the
A. Antifriction properties
What is the correct answer?
4
According to thermodynamic Fahrenheit scale, the fundamental interval between ice point to steam point is
What is the correct answer?
4
In practice, the compression ratio of compression-ignition (CI) engine ranges from
What is the correct answer?
4
The leaching solvent used in Baeyer's process for the purification of bauxite is
What is the correct answer?
4
A psychrometer does not measure the __________ temperature of moist air.
What is the correct answer?
4
A material being tested for endurance strength is subjected to the __________ load.
What is the correct answer?
4
Lead is poured into the joint between two- __________ pipes.
What is the correct answer?
4
Which of the following approaches the ideal gas behaviour most closely?
What is the correct answer?
4
Heat required to raise the temperature of a body by 1 °C is called its
B. Specific heat capacity
What is the correct answer?
4
The majority charge carriers in p-type silicon are
What is the correct answer?
4
Brass parts with high residual tensile stress at the surface are susceptible to season cracking (i.e. spontaneous cracking occuring on exposure to atmospheric corrosion), if its zinc percentage is more than
What is the correct answer?
4
A fire tube boiler is limited to a maximum steam pressure of about __________ kg/cm2.
What is the correct answer?
4
Which of the following is used to produce draught in the locomotive boilers?
What is the correct answer?
4
A particle is settling in a liquid under Stokesian conditions. The free falling velocity of the particle is proportional to
What is the correct answer?
4
Which of the following relationships is correct for relating the three elastic constants of an isotropic elastic material (where, E = Young's modulus, G = Modulus of rigidity or shear modulus v = Poisson's ratio)?
What is the correct answer?
4
Which of the following rays has the least wavelength?