A.
Non-crystalline organic polymeric
Ceramic
All crystalline
All amorphous
Carbon dioxide
Carbon monoxide
Oxygen
Air
75-100
200-300
350-450
500-600
Bubble generation is by expansion of entrapped gas/vapour at small cavities in the surface
Surface temperature is greater than the saturation temperature of the liquid
Heat transfer from the surface of the liquid is less than that in film boiling
The temperature is less than that of film boiling
Tempering
Chromising
Aluminising
Alloying
Semi-conductor
Metal or alloy
Dielectric
None of these
Work hardening
Bauschinger effect
Creeping effect
Stress recovery effect
Speed of the extruded material is same as that of ram speed
Redundant work is a function of the die angle
Relative motion between the billet surface and the container wall is always present
Hollow ram is used for indirect extrusion
Newton's second law of motion
Newton's third law of motion
Law of projectiles
Archimedes principle
Pressure change to temperature change occuring during adiabatic compression of a gas
Pressure change to temperature change occuring during adiabatic throttling of a gas
Temperature change to pressure change occuring during adiabatic compression of a gas
Temperature change to pressure change occuring during adiabatic throttling of a gas
Waiting
Idle
Inspection
Tool replacement
Intensifies deterioration
Changes the composition of the metal
Inhibits further deterioration
None of these
Air
Oxygen
Liquid medium
Gaseous medium
Decreases with the increase of concentration of the solute
Increases with the increase of concentration of the solute
Remains constant
Is unity at infinite dilution
Molybdenum
Nickel
Manganese
Chromium
1
1.4
1.5
Y = Cp/Cv
0.25
0.45
0.70
0.95
A ferromagnetic material becomes paramagnetic above the 'Curie temperature'
Permanent magnets are made of hard materials, whereas electromagnets require soft magnetic materials
Soft magnetic materials (e.g., pure iron) have higher permeability and low hysterisis loss and coercive forces
Tungsten steel and alnico are not hard magnetic materials
Suppress martensite transformation
Enhance its working performance in sub zero atmosphere
Reduce the retained austenite in hardened steel
Induce temper brittleness after its hardening
Hexagonal close, packed (hcp)
Face centred cubic (fcc)
Body centred cubic (bcc)
Simple cubic
Grashoff number
Grashoff number & Reynolds number
Reynolds number
Grashoff number & Prandtl number
H+ ions are absent
OH- ions are absent
Both H+ and OH- ions are present in very small but equal concentration
None of these
Black
Silver grey
Green
Yellow
746
3000
1000
550
More
Less
Equal
Much more
Kudremukh
Kolar
Khetri
Ramagundam
<100
>100
About 273
About 373
Plasticiser: increases the polymer strength
Heat stabiliser: increases the maximum service temperature
Fillers: Does not affect the property of polymer but increases its weight
Lubricants: increases the flexibility of polymers
Normalising
Annealing
Tempering
Hardening
Cast iron
Hypo-eutectoid steel
Hyper-eutectoid steel
Eutectoid steel