Home

__________ test can be termed as the semidestructive test.

A. Impact

B. Torsion

C. Hardness

D. Charpy

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. __________ is the trade name assigned to a nonferrous cast alloy composed of cobalt, chromium & tungsten.
  2. Faraday's law of electrolysis is related to the
  3. Case hardening of a material is
  4. Fatigue resistance of a material is measured by the
  5. Hooke's law
  6. __________ is a non volatile film forming constituent of a paint.
  7. Sub zero treatment of steel is done to
  8. There are one octahedral void and __________ tetrahedral void in the closest packing of atoms.
  9. Closeness of packing is maximum in case of __________ crystal lattice.
  10. Use of flux during soldering is done to
  11. A material is capable of resisting softening at high temperature, because of its property termed as
  12. The most prominent single cause of corrosion in boiler-tubes, drums, economisers and steam superheaters…
  13. On oscilloscope screen for dynamic measurement, lissajous diagram is normally used to determine the…
  14. Absolute zero, pressure will occur, when the molecular momentum of the system becomes zero. A liquid…
  15. Volume of blast furnace slag is about __________ times the volume of hot metal (pig iron) of the same…
  16. 'Flare tower' used in industry is meant for
  17. What is the value of included angle of a triangular notch for maximum discharge?
  18. Maximum consumption of limestone is in the __________ industry.
  19. The cooling rate required to freeze 1 ton of water at 0°C into ice at 0°C in 24 hours is __________…
  20. Yield strength of a polycrystalline metal with an average grain size d, is proportional to
  21. Wood is a/an __________ material.
  22. An approximately __________ process exemplifies the flow of a gas through a very long pipe of uniform…
  23. Wave length of X-rays is about 1 angstrom; however it cannot pass through a sheet of
  24. Tumbling is the process of improving the __________ of the materials/parts.
  25. In TIG welding, thoriated tungsten electrodes are used, because it
  26. Unbreakable crockeries are made from __________ polymers.
  27. Venturimeter is used to measure the flow rate of fluids in pipes, when the pipe is in __________ position.
  28. Force between the molecules of the same substance is called __________ force.
  29. Steel rods are normally used for concrete reinforcement because concrete and steel have almost equal
  30. A polymer is termed as an 'elastomer', if its percentage elongation is more than 100%. An elastomer…