It evolves a great amount of steam and other gases
The sand grains stick together
It clings to the sides of a moulding box
None of these
C. It clings to the sides of a moulding box
Simple die
Progressive die
Combination die
Compound die
Rough file
Bastard file
Second cut file
Smooth file
Grinding the cutting edges sharp
Increasing the hardness of tool
Providing shear on tool
Increasing the hardness of die
Neutral flame and rightward technique
Oxidising flame and leftward technique
Neutral flame and leftward technique
Carburising flame and rightward technique
Two or more operations are performed simultaneously at the single stroke of the ram
Two or more cutting operations are performed at one station of the press in every stroke of the ram
Both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram
None of the above
Washing it with water
Rubbing on wood
Washing it with dilute acid
Using file card
Same as
Less than
More than
None of these
Age hardening
Work hardening
Induction hardening
Flame hardening
The angular clearance on dies varies from 0.5° to 1°
In drawing operation, the metal flows due to plasticity
In press operation, the size of the pierced hole is independent of the size of punch
None of the above
Die casting method
Slush casting method
Permanent mould casting method
Centrifugal casting method
Refining grain size
Reducing original block into desired shape
Controlling the direction of flow lines
All of these
Equal volumes of oxygen and acetylene
More volume of oxygen and less volume of acetylene
More volume of acetylene and less volume of oxygen
None of the above
Only one operation is performed at each stroke of the ram
Two or more operations are performed simultaneously at the single stroke of the ram
Two or more cutting operations are performed at one station of the press in every stroke of the ram
Both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram
Die casting method
Slush casting method
Permanent mould casting method
Centrifugal casting method
Chills and chaplets
Chills and padding
Chaplets and padding
Chills, chaplets and padding
Is extensively used for making bolts and rivets
Is used for reducing the diameters of round bars and a tube by rotating dies which open and close rapidly on the work
Is used to improve fatigue resistance of the metal by setting up compressive stresses in its surface
Consists of pressing the metal inside a chamber to force it out by high pressure through an orifice which is shaped to provide the desired form of the finished part
From left to right
From right to left
First from left to right and then from right to left
Either from left to right or from right to left
Simple die
Progressive die
Combination die
Compound die
Do not require bevelling
Should be bevelled to a single-V or U-groove
Should have a double-V or U-groove on one side
Should have a double-V or U-groove on both sides
Drawing
Extrusion
Rolling
Extrusion and rolling
Equal to
Smaller than
Larger than
None of these
30% sand and 70% clay
50% sand and 50% clay
70% sand and 30% clay
90% sand and 10% clay
At the recrystallisation temperature
Below the recrystallisation temperature
Above the recrystallisation temperature
At any temperature
0.025 to 3 mm
3 to 5 mm
5 to 8 mm
8 to 10 mm
Steel
Cast iron
Copper
All of these
Cross filing
Draw filing
Pull and push filing
None of these
Do not require bevelling
Should be bevelled to a single-V or U-groove
Should have a double-V or U-groove on one side
Should have a double-V or U-groove on both sides
Forward stroke
Return stroke
Both forward and return strokes
None of these
Simple die
Progressive die
Compound die
Combination die
Neutral flame
Oxidising flame
Carburising flame
All of these