Related Questions
What is the correct answer?
4
Calm period is the percentage of time during which wind intensity is less than
What is the correct answer?
4
Total correction for elevation, temperature and gradient for a runway should not be more than
What is the correct answer?
4
In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be
What is the correct answer?
4
Airport elevation is the reduced level above M.S.L. of
B. Highest point of the landing area
C. Lowest point of the landing area
What is the correct answer?
4
Pick up the correct statement from the following:
A. Runway edge from the landing side, is called threshold
B. Localizer indicates to the pilot his position with respect to the proposed alignment
C. The glide slope indicates the correct angle of descent
What is the correct answer?
4
Which of the following factors are taken into account for estimating the runway length required for aircraft landing?
1. Normal maximum temperature
2. Airport elevation
3. Maximum landing weight
4. Effective runway gradient Select the correct answer using the codes given below Codes:
What is the correct answer?
4
Beaufort scale is used to determine
What is the correct answer?
4
The runway orientation is made so that landing and takeoff are
A. Against the wind direction
B. Along the wind direction
C. Perpendicular to wind direction
What is the correct answer?
4
An airport has 4 gates. If the weighted average gate occupancy time is 30 minutes and gate utilisation factor is 0.5, then the capacity of the gate will be
What is the correct answer?
4
The length of clear zone for none instrument runway of a small aircraft is
What is the correct answer?
4
The lift off distance is the distance along the centre of the runway between the starting point and
C. Point where air craft becomes air borne
D. Point where air craft attains a height of 10.7 m
What is the correct answer?
4
The thickness design of the pavement, is decided on the load carried by
What is the correct answer?
4
The landing and takeoff of the air craft is made against the direction of wind. In no case the centre line of the runway should make an angle with the wind direction exceeding
What is the correct answer?
4
Castor angle is defined as the angle
A. Formed by the longitudinal axis of the aircraft and the direction of movement of the nose gear
B. Between the direction of wind and the longitudinal axis of the runway
C. Between the true speed of the aircraft and the crosswind component
D. Between the horizontal and the fuselage axis
What is the correct answer?
4
If lift off distance of an craft is 2000 m, the clear way at the end of the runway should not be less than
What is the correct answer?
4
The main disadvantage of angle nose out parking configuration of aircraft is that the
A. Aircraft rear loading door is far away from terminal building.
B. Hot blast is directed towards the terminal building
C. Overall apron area required is more
What is the correct answer?
4
The cruising speed of the aircraft is 500 kmph. If there is a head wind of 50 kmph, then the air speed and ground speed of the aircraft respectively will be
What is the correct answer?
4
Speed of
A. Sound at 0°C is 1190 kmph
B. Sound varies 2.4 kmph per degree centigrade rise in temperature
C. Sound at 0°C is called one Mach
What is the correct answer?
4
The slope of the transitional surface for A, B and C type of runway shall be
What is the correct answer?
4
The length of runway is increased per 300 m rise above M.S.L.
What is the correct answer?
4
If the width of the approach area near the runway end is 150 m, the width of the approach area at a distance of 3 kilometres from runway end will be
What is the correct answer?
4
The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to
What is the correct answer?
4
Pick up the correct statement from the following:
A. Approximate geometric centre of the landing area, is called air port reference point
B. The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
C. The location of the air port on a map is the position of air port reference point
What is the correct answer?
4
Pick up the correct statement from the following:
A. Air screw converts the energy given by the engine into speed
B. The propellers which are driven by turbine engines, are technically called turboprops
C. The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
What is the correct answer?
4
If the monthly mean of average daily temperature for the hottest month of the year is 25°C and the monthly mean of the maximum daily temperature of the same month of the year is 46°C, the airport reference temperature is
What is the correct answer?
4
According to the International Civil Aviation Organisation (I.C.A.O.), the runway lengths of aerodromes, have been coded by
A. Seven English alphabets
B. Last Seven English alphabets
C. First Seven English alphabets
D. First seven natural numbers
What is the correct answer?
4
For night landing, the thresholds are lighted
What is the correct answer?
4
The engine failure case for determining the basic runway length may require
C. Either a clearway or a stop-way
D. Either a clearway or a stop-way or both
What is the correct answer?
4
Pick up the correct statement from the following:
A. Landing speed is directly proportional to the wing loading
B. Wing loading remaining constant, the take off distance is directly proportional to the powder loading
What is the correct answer?
4
The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is