Adjust the tyre pressure
Rotate the tyres
Adjust the damper spring tension
Attach appropriate weights to the wheel at appropriate positions
D. Attach appropriate weights to the wheel at appropriate positions
Oil strainer, oil pump, relief valve, oil filter, cylinder block, cylinder head and oil pan
Oil pump, oil strainer, relief valve, oil filter, cylinder block, cylinder head and oil pan
Oil strainer, oil filter, relief valve, oil pump, cylinder block, cylinder head and oil pan
Oil strainer, oil pump, relief valve, oil filter, cylinder head, cylinder block and oil pan
Improved fuel efficiency
Improved emission
Improved power output
All of these
Brake drags
Brake fades
Vapour locking occurs in the brake lines
Antilock braking system malfunctions
Power
Fuel consumption
Engine r.p.m.
Distance
Release chamber
Balancer
Relief valve
Stop valve
Tendency to assume toe-out orientation
Generation of a braking effect at tight corners
Poor recovery of the steering wheel after making a turn
The vehicle to pull to the side of lesser inclination
Unsprung mass is kept minimum
Sprang mass is kept minimum
Vehicle mass is kept minimum
All of these
Piston oil hole
Snap ring
Valve recess
Valve clearance
Cap bolt
Piston pin
Cap roller bearing
Rod cap
To vary the speed of automobile
To vary the torque at the wheels
To vary the power of automobile
None of these
Mix the fuel and air
Ignite the air-fuel mixture
Provide flame front for ignition
Spray atomized fuel in the cylinder
1.6694 N
16.694 N
166.94 N
1669.4 N
Smaller than the positive terminal post
Larger than the positive terminal post
Of the same size as the positive terminal post
None of these
It makes petrol engines lighter
Higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition
Less compression ratio gives better performance
It is just customary to have less compression ratio in petrol engines
1-2-3-4
1-3-4-2
1-2-4-3
1-3-2-4
Mechanically
Hydraulically
Pneumatically
None of these
Crown of the piston
Skirt of the piston
Piston walls
Piston rings
Engine is cold
Engine overheats
Oil filter becomes clogged
Engine runs at high speed
Absorb the vibrations transferred from the surface of the road
Compensate for variations in the relative positions of the differential and the wheels which result from bumpy road surfaces or other similar driving conditions.
Absorb any difference in speed between the left and right wheels when the vehicle is turning
None of the above
500 rpm
1000 rpm
2000 rpm
4000 rpm
Front wheels
Rear wheels
Front and rear wheels
Propeller shaft
Aluminium
Ceramic
Brass
Cast iron
Optimisation of exhaust efficiency
Reduction of exhaust noise
Reduction of nitrogen oxide in the exhaust gases
Reduction of the exhaust gas volume
Cast iron and steel
Cast iron and aluminium alloy
Steel and aluminium alloy
Brass and steel
4 : 1
8 : 1
15 : 1
20 : 1
One ply layer runs diagonally one way and another layer runs diagonally the other way
All plies run parallel to one another and vertical to tyre bead
Inner tubes are always used
None of these
I.P/B.P.
B.P/I.P.
B.P/F.P.
F.P/B.P.
8.091 Nm
80.91 Nm
809.1 Nm
8091 Nm
Increase vehicle load carrying capacity
Provide a softer ride
Control suspension movement and body roll
All of the above
Reduce the resistance to sliding that occurs between the cam and the tappet
Allow for lengthening of the valves owing to the heat of combustion
Increase the speed at which the valves move up and down
Make the crankshaft turn smoothly