Home

The dimensional formula of bulk modulus of elasticity is same as that of the

A. Pressure

B. Density

C. Force

D. None of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The concentration of (H+) ions is 4 x 10-5 in a solution. Then pH of the solution will be (Given log…
  2. With increase in temperature, the surface tension of water
  3. Oxide layer formed on the non-ferrous metal surface after its annealing is
  4. Powder metallurgy process does not make metal powder by
  5. Wrought iron is never shaped by
  6. Softening of hardened steel is done by its
  7. Inertial forces are obtained, when the elastic forces are multiplied by __________ number.
  8. Transformation range for ferrous material is the temperature interval during which __________ is formed…
  9. at 1173E; at equilibrium, what will be the number of moles of CO gas required to reduce one mole of…
  10. Which of the following is not categorised as the ore agglomeration process?
  11. Which of the following phenomenon will exhibit the minimum heat transfer?
  12. Normalising does not __________ of a metal.
  13. Ammonia gas can be dried by
  14. Steel rods are normally used for concrete reinforcement because concrete and steel have almost equal
  15. Dryness factor of steam is defined as the ratio of the mass of vapor in the mixture to the mass of the…
  16. Addition of __________ to steel does not help in improving its machinability.
  17. Blow off cock is provided in steam boiler to
  18. Air/fuel ratio by weight for combustion of methane with theoretical quantity of air will be about
  19. The maximum thickness of the metal which can be welded using ultrasonic welding is __________ mm.
  20. Exposure to __________ accelerates the degradation of plastics.
  21. Filler material used in welding should have __________ as compared to the parent metal to be welded.
  22. Closeness of packing is maximum in case of __________ crystal lattice.
  23. The __________ of a double acting reciprocating pump as compared to the single acting pump will be almost…
  24. Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel &…
  25. Pressure exerted by a liquid depends upon its
  26. Maximum permissible sulphur content in steel is __________ percent.
  27. Use of flux during soldering is done to
  28. The majority charge carriers in p-type silicon are
  29. Increase in temperature, in general results in the
  30. The most important consideration, while designing the refrigeration system of an aircraft is that the…