Related Questions
What is the correct answer?
4
The capacity of a strained body for doing work on the removal of the straining force, is called
What is the correct answer?
4
The compression ratio for petrol engines is
What is the correct answer?
4
The strain energy stored in a body due to suddenly applied load compared to when it is applied gradually is
What is the correct answer?
4
A continuous beam is one which is
B. Fixed at one end and free at the other end
C. Supported on more than two supports
D. Extending beyond the supports
What is the correct answer?
4
Those substances which have so far not been resolved by any means into other substances of simpler form are called
What is the correct answer?
4
The amount of heat required to raise the temperature of the unit mass of gas through one degree at constant volume, is called
A. Specific heat at constant volume
B. Specific heat at constant pressure
What is the correct answer?
4
The __________ states that change of internal energy of a perfect gas is directly proportional to the change of temperature.
What is the correct answer?
4
The shear force at the centre of a simply supported beam with a gradually varying load from zero at both ends to w per metre at the centre, is
What is the correct answer?
4
Which of the following materials is most elastic?
What is the correct answer?
4
The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates, and σt, τ and σc = Permissible tensile, shearing and crushing stresses respectively)
What is the correct answer?
4
In a free expansion process,
What is the correct answer?
4
The energy absorbed in a body, when it is strained within the elastic limits, is known as
What is the correct answer?
4
In the below figure, the plastic range occurs
C. Between points A and D
D. Between points D and E
What is the correct answer?
4
A tri-atomic molecule consists of __________ atoms.
What is the correct answer?
4
The molecular mass expressed in gram (i.e. 1 g - mole) of all gases, at N. T. P., occupies a volume of
What is the correct answer?
4
An open system is one in which
A. Heat and work crosses the boundary of the system, but the mass of the working substance does not crosses the boundary of the system
B. Mass of the working substance crosses the boundary of the system but the heat and work does not crosses the boundary of the system
C. Both the heat and work as well as mass of the working substance crosses the boundary of the system
D. Neither the heat and work nor the mass of the working substance crosses the boundary of the system
What is the correct answer?
4
High air-fuel ratio in gas turbines
A. Increases power output
B. Improves thermal efficiency
C. Reduces exhaust temperature
D. Do not damage turbine blades
What is the correct answer?
4
A process of heating crude oil to a high temperature under a very high pressure to increase the yield of lighter distillates, is known as
C. Fractional distillation
What is the correct answer?
4
A column of length (l) with both ends fixed may be considered as equivalent to a column of length __________ with both ends hinged.
What is the correct answer?
4
The total strain energy stored in a body is termed a
What is the correct answer?
4
Shear stress induced in a shaft subjected to tension will be
A. Maximum at periphery and zero at center
What is the correct answer?
4
Kelvin-Planck's law deals with
C. Conversion of heat into work
D. Conversion of work into heat
What is the correct answer?
4
For a simply supported beam of length l, when a concentrated load W is applied in the centre of the beam, the maximum deflection is
What is the correct answer?
4
A beam is loaded as cantilever. If the load at the end is increased, the failure will occur
B. At the tip below the load
What is the correct answer?
4
The efficiency of Carnot cycle is maximum for
What is the correct answer?
4
When a system changes its state from one equilibrium state to another equilibrium state, then the path of successive states through which the system has passed, is known as
What is the correct answer?
4
The efficiency of the Carnot cycle is (where T1 and T2 = Highest and lowest temperature during the cycle)
What is the correct answer?
4
A cycle consisting of two adiabatic and two constant pressure processes is known as
What is the correct answer?
4
Diesel cycle consists of following four processes
A. Two isothermal and two isentropic
B. Two isentropic and two constant volumes
C. Two isentropic, one constant volume and one constant pressure
D. Two isentropic and two constant pressures
What is the correct answer?
4
When a closely-coiled helical spring of mean diameter (D) is subjected to an axial load (W), the stiffness of the spring is given by