CV2

C2/J

C/V

J/V2

**What is the specific resistance of a pure silicon?****Inductive reactance applies only to sine waves because it****How many coulombs are delivered by a storage battery in 25 hours if it is supplying current at the rate…****The presence of an electric current is made known by****Which of the following is not considered a physical factor affecting resistance?****The ratio of the flux density to the electric field intensity in the dielectric is called****Another term for superconductor.****The Q-factor of a parallel resonant circuit is also known as****The factor 0.707for converting peak to rms applies only to****In a series RLCcircuit****Which is considered as the effect of a dielectric material?****Thevenin¶s theorem is what form of an equivalent circuit?****Which of the following capacitors has the highest cost per F?****The charging of a capacitor through a resistance obeys****A capacitor is basically constructed of****The admittance of a parallel RLC circuit is found to be the ___ sum of conductance and susceptances.****According to Gauss theorema flux can be equated to****Which of the following is the statement of Ohm¶s law?****If an emf in circuit A produces a current in circuit Ba then the same emf in circuit Bproduces the same…****It is impossible to change the voltage across a capacitor instantlya as this would produce ___ current.****Series resonant circuit is sometimes known as****An open resistor when checked with an ohmmeter reads****Points to be considered in choosing a capacitor****What is the peak factor for alternating current or voltage varying sinusiodally?****A wire of one kilometre length has a resistance of 20 . If the length is halveda then the new resistance…****A linear circuit is one whose parameters****Parallel resonant circuit is sometimes called as****What is the resonant frequency of a circuit when L of 25 microhenrys and C of 10 picofarads are in parallel?****The hot resistance of an incandescent lamp is about ___ times its cold resistance.****What is the efficiency under the conditions of maximum power transfer?**