Home

The fatigue stress concentration factor is defined as

A. The ratio of endurance limit with stress concentration to the endurance limit without stress concentration

B. The ratio of endurance limit without stress concentration to the endurance limit with stress concentration

C. The product of the endurance limits with and without stress concentration

D. All of the above

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Resistance to fatigue of a material is measured by
  2. The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover…
  3. The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of…
  4. The application of third type levers is found in
  5. According to Indian standard specifications, 100 H6/g5 means that
  6. The size of a cam depends upon
  7. The objective of caulking in a riveted joint is to make the joint
  8. Which one of the following is a positive drive?
  9. Which of the following coupling is used to connect two shafts which have both lateral and angular misalignment?
  10. In case of pressure vessels having open ends, the fluid pressure induces
  11. The endurance limit of a material with finished surface in comparison to rough surface is
  12. In worm gears, the angle between the tangent to the pitch helix and an element of the cylinder, is known…
  13. The circumferential and longitudinal strains in a cylindrical boiler under internal steam pressure are…
  14. Taper usually provided on cotter is
  15. When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and…
  16. In unilateral system of tolerance, the tolerance is allowed on
  17. The material commonly used for crane hooks is
  18. The resultant axial load on a bolt depends upon
  19. Wire ropes as compared to cotton ropes
  20. A tap bolt
  21. In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole…
  22. The stress in the threaded part of the bolt will be __________ as compared to the shank.
  23. In leaf springs, the longest leaf is known as
  24. For hardening alloy steels and high speed steels, they are heated to
  25. In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set…
  26. The speed of the sprocket reduces as the chain pitch __________ for a given number of teeth.
  27. In most machine members, the damping capacity of the material should be
  28. The pipe joint mostly used for pipes carrying water at low pressures is
  29. The fatigue stress concentration factor is defined as
  30. In a steam engine, the piston rod is usually connected to the crosshead by means of a