The first step in creating a traditional technical drawing is to ________.
Draw a series of guide lines
Set up the meter line
Align the paper so that it will be positioned square to the parallel bar
Sharpen the leads in the technical pens
- The edges of a cube in isometric projection make angles of this many degrees with each other:
- Generally, the units used on an architectural drawing are set to ________.
- By using a ________ section of a cylindrical mechanical part the drafter should be able to show only…
- 5.These items typically are not used in new designs, but are still common in high-power amplifiers:
- This type of solid is egg-shaped and can be created by revolving an ellipse around one of its axes:
- Architectural dimensioning is usually done in ________.
- The ________ is a standard element of a section view in a technical drawing.
- This is used to indicate that a surface is to be machined:
- This is the range of digital or hard copy documents that specify the physical function requirements…
- Angles project true size only when the plane containing the angle and plane of projection are this:
- The building construction industry relies on sets of ________ drawings to construct homes and commercial…
- In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in…
- To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
- The architectural drafter usually begins a set of working drawings by creating the ________ plan first.
- A back or backing weld is a type of:
- An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
- These units are based on inch-foot and yard measurements:
- In this type of section, one quarter of the object is removed:
- An oil refinery relies on which type of drafter to maintain and update the technical piping drawings…
- The Free Orbit tool is found on the ________ toolbar.
- To insure that everyone understands what the electrical symbols represent it is customary to include…
- In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
- These gears transmit power between shafts whose axes intersect at any angle:
- These are special installations of stone or concrete marking the locations of points accurately determined…
- Three dimensional models are often used in the design process to __________.
- Some traditional board drafters preferred the drafting machine over the parallel straight edge because…
- The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
- The site plan illustrates ________.
- Isometric drawings are often used by ________ to help illustrate complex designs.
- A fillet is a rounded surface on the ________ corner of a part.