Home

The Free Orbit tool is found on the ________ toolbar.

A. Rotate

B. Move

C. Modify

D. 3-D Move

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
  2. Some traditional board drafters preferred the drafting machine over the parallel straight edge because…
  3. Angles project true size only when the plane containing the angle and plane of projection are this:
  4. When using versions of Auto-CAD prior to Release 2006 it may be necessary to ________ a block in order…
  5. A secondary auxiliary view is a projection off of the ________.
  6. Understanding the Cartesian coordinate system will help the beginning drafter ________.
  7. A half-moon protractor is divided into how many degrees?
  8. The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
  9. This is a rounded exterior blend between surfaces:
  10. The ________ is a standard element of a section view in a technical drawing.
  11. Placement of dimensions on a drawing is controlled by ________.
  12. In this type of view, the cutting plane line indicates both the location of the cutting plane and the…
  13. If designs require changes, they should be documented with:
  14. These drawings are given to contractors to perform work or manufacture individual parts:
  15. When creating a block the drafter needs to pay particular attention to selecting a base point because…
  16. By using a ________ section of a cylindrical mechanical part the drafter should be able to show only…
  17. In this type of dimensioning, allowance must be made for bends:
  18. It is customary for the first sheet of a working drawing set to include ________.
  19. This type of section is not in direct projection from the view containing the cutting plane:
  20. Lines of an isometric drawing that are not parallel to the isometric axes are called this:
  21. A full scale technical drawing will have a scale factor of ________.
  22. In an oblique drawing, equally spaced partial circles may be used to show this:
  23. The site plan illustrates ________.
  24. Generally, the units used on an architectural drawing are set to ________.
  25. This is the measured size of a finished part:
  26. This type of thread is a thread on the inside of a member:
  27. In the mechanical design process the first step is to ________.
  28. When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate…
  29. In oblique projection, important shapes should be in this position relative to the viewing plane:
  30. Drawings created with commercial software are typically saved as: