The frictional torque transmitted in a conical pivot bearing, considering uniform wear, is
(1/2) μ W R cosec α
(2/3) μ W R cosec α
(3/4) μ W R cosec α
μ W R cosec α
Also checkout these categories
Indian Polity & Economy MCQ Problems on Trains MCQ Surface Area MCQ Human reproductive system MCQ Fungi and Lichens MCQ Transmission of Heat MCQ Networking MCQ Current Affairs May 2017 MCQ Mechanical Engineering MCQ Data Sufficiency MCQ Active and Passive Voice MCQ True Discount MCQ
- Which of the following property of the instantaneous centre is correct?
- The centre distance between two meshing involute gears is equal to
- When the primary direct crank of a reciprocating engine makes an angle of θ with the line of stroke,…
- In the below figure, PC is the connecting rod and OC is the crank making an angle θ with the line…
- When the crank is at the inner dead centre, in a reciprocating steam engine, then the velocity of the…
- There are six gears A, B, C, D, E and F in a compound train. The numbers of teeth in the gears are 20,…
- The example of successfully constrained motion is a
- The Klein's diagram is useful to find
- Which of the following mechanism is obtained from lower pair?
- The Klein's method of construction for reciprocating engine mechanism
- The natural frequency of free transverse vibrations due to uniformly distributed load acting over a…
- In gears, interference takes place when
- When a rigid body is suspended vertically and it oscillates with a small amplitude under the action…
- The partial balancing of reciprocating parts in locomotives produces
- The maximum efficiency of spiral gears is (where θ = Shaft angle, and φ = Friction angle)
- The tractive force in a locomotive with two cylinders is given by (where c = Fraction of reciprocating…
- A mechanism consisting of four links is called a __________ mechanism.
- The radial distance from the top of a tooth to the bottom of a tooth in a meshing gear, is called
- A flywheel is fitted to the crankshaft of an engine having W as the amount of indicated work per revolution…
- The periodic time of one oscillation for a simple pendulum is
- Which one of the following can completely balance several masses revolving in different planes on a…
- The tractive force is maximum or minimum when the angle of inclination of crank with the line of stroke…
- In a gear having involute teeth, the normal to the involute is a tangent to the
- Angle of descent of cam is defined as the angle
- The component of the acceleration, perpendicular to the velocity of the particle, at the given instant…
- The sensitiveness of the governor __________ as the speed range decreases.
- A Porter governor is a
- The secondary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given…
- Davis steering gear consists of
- Sense of tangential acceleration of a link