The heat supplied to the gas at constant volume is (where m = Mass of gas, cv = Specific heat at constant volume, cp = Specific heat at constant pressure, T2 - T1 = Rise in temperature, and R = Gas constant)

A. mR (T2 - T1)

B. mcv (T2 - T1)

C. mcp (T2 - T1)

D. mcp (T2 + T1)

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. According to Kelvin-Planck's statement of second law of thermodynamics,
  2. Flow stress corresponds to
  3. Efficiency of a riveted joint is the ratio of its strength (max. load it can resist without failure)…
  4. For the same compression ratio, the efficiency of Diesel cycle is __________ Otto cycle.
  5. Reversed Joule cycle is known as
  6. When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear…
  7. The amount of heat required to raise the temperature of 1 kg of water through one Kelvin is called
  8. The polytropic index (n) is given by
  9. A cycle consisting of two isothermal and two isentropic processes, is known as
  10. The variables which control the physical properties of a perfect gas are
  11. The fuel mostly used in steam boilers is
  12. The isothermal and adiabatic processes are regarded as
  13. The strain energy stored in a solid circular shaft subjected to shear stress (τ), is: (Where G…
  14. The relation between equivalent length (L) and actual length (l) of a column for both ends fixed is
  15. Workdone in a free expansion process is
  16. The thermal efficiency of an ideal gas turbine plant is given by (where r = Pressure ratio)
  17. The value of cp/cv for air is
  18. In a uniform bar, supported at one end in position, the maximum stress under self weight of bar shall…
  19. Formula based on IS codes is based on
  20. Which of the following has the highest calorific value?
  21. Otto cycle is also known as
  22. When the gas is cooled at constant pressure,
  23. In the tensile test, the phenomenon of slow extension of the material, i. e. stress increasing with…
  24. A cantilever beam is one which is
  25. Percentage reduction of area in performing tensile test on cast iron may be of the order of
  26. Which of the following statement is wrong?
  27. Steam coal is a
  28. The assumption made in Euler's column theory is that
  29. In an ideal gas turbine plant, it is assumed that the compression and expansion processes are
  30. The strain energy stored in a body due to suddenly applied load compared to when it is applied gradually…