Home

The Hooke's joint consists of:

A. Two forks

B. One fork

C. Three forks

D. Four forks

Related Questions

  1. In a four-bar chain it is required to give an oscillatory motion to the follower for a continuous rotation…
  2. In a simple train of wheels, the velocity ratio __________ the intermediate wheels.
  3. In a locomotive, the maximum magnitude of the unbalanced force along the perpendicular to the line of…
  4. Which of the following statement is correct for involute gears?
  5. For the brake to be self locking, the force P at C shown in the below figure, should
  6. For low and moderate speed engines, the cam follower should move with
  7. If the pressure angle is __________, a reciprocating follower will jam in its bearings.
  8. When the addenda on pinion and wheel is such that the path of approach and path of recess are half of…
  9. The mechanism forms a structure, when the number of degrees of freedom (n) is equal to
  10. The rotating shafts tend to vibrate violently at whirling speeds because
  11. Shaft revolving in a bearing is the following type of pair
  12. Module of a gear is
  13. The two parallel and coplanar shafts are connected by gears having teeth parallel to the axis of the…
  14. A disc is a spinning with an angular velocity ω rad/s about the axis of spin. The couple applied…
  15. Power of a governor is the
  16. In vibration isolation system, if ω/ωn > 1, then the phase difference between the transmitted…
  17. Transmission of power from the engine to the rear axle of an automobile is by means of
  18. Kinematic pairs are those which have
  19. When the two elements of a pair have __________ when in motion, it is said to a lower pair.
  20. In a screw jack, the effort required to lift the load W is given by (where α = Helix angle, and…
  21. In under damped vibrating system, if x₁ and x₂ are the successive values of the amplitude…
  22. Which of the following mechanism is obtained from lower pair?
  23. The Coriolis component of acceleration acts
  24. The static balancing is satisfactory for low speed rotors but with increasing speeds, dynamic balancing…
  25. Transmission angle is the angle between
  26. A point on a connecting link (excluding end points) of a double slider crank mechanism traces a
  27. When a body is subjected to transverse vibrations, the stress induced in a body will be
  28. The partial balancing of reciprocating parts in locomotives produces
  29. The Klein's method of construction for reciprocating engine mechanism
  30. The fundamental equation for correct steering is (where φ and α = Angle through which the…

Please do not use chat terms. Example: avoid using "grt" instead of "great".