Home

The __________ is obtained when carbonisation of coal is carried out at 500° to 700° C.

A. Soft coal

B. Hard coal

C. Pulverised coal

D. Bituminous coal

Related Questions

  1. The cycle in which heat is supplied at constant volume and rejected at constant pressure is known as
  2. The columns whose slenderness ratio is less than 80, are known as
  3. The ratio of maximum shear stress developed in a rectangular beam and a circular beam of the same cross-sectional…
  4. Resilience is the
  5. If the radius of wire stretched by a load is doubled, then its Youngs modulus will be
  6. Young's modulus is defined as the ratio of
  7. The stress necessary to initiate yielding is
  8. The maximum tangential stress in a thick cylindrical shell is always _________ the internal pressure…
  9. In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress…
  10. According to Kelvin-Planck's statement, a perpetual motion of the __________ is impossible.
  11. The general gas equation is (where p = Pressure, v = Volume, m = mass, T = Absolute temperature, and…
  12. An open system is one in which
  13. When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear…
  14. Strain is defined as the ratio of
  15. The polytropic index (n) is given by
  16. The stress induced in a body due to suddenly applied load compared to when it is applied gradually is
  17. Carbonisation of coal consists of
  18. According to Kelvin-Planck's statement of second law of thermodynamics,
  19. The oxygen atom is ________ times heavier than the hydrogen atom.
  20. Which of the following is an intensive property of a thermodynamic system?
  21. When two plates are butt together and riveted with cover plates with two rows of rivets, the joint is…
  22. Shear stress induced in a shaft subjected to tension will be
  23. Which of the following gas has the highest calorific value?
  24. The value of 1 mm of Hg is equal to
  25. Which of the following process can be made reversible with the help of a regenerator?
  26. The heat flows from a cold body to a hot body with the aid of an external source. This statement is…
  27. The ratio of the largest load in a test to the original cross-sectional area of the test piece is called
  28. Carnot cycle consists of
  29. The ratio of direct stress to volumetric strain in case of a body subjected to three mutually perpendicular…
  30. The torsional rigidity of a shaft is expressed by the

Please do not use chat terms. Example: avoid using "grt" instead of "great".