The ___________ is the point where the carrier's responsibility ends and yours begins.
Local loop
Demarcation point
CPE
Toll network
Correct Answer :
B. Demarcation point
Related Questions
Which of the following is not an advantage of DHCP?
It allows for the use of private addressing.
It reduces the amount of configuration on devices.
It reduces likelihood of configuration errors.
It gives you more control by centralizing IP addressing information.
There are _________ actions a router can take when there is a match on an ACL statement
1
2
3
4
A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.
SAN
LAN
CN
SAN and CN
__________ allows you to distribute connection requests destined to a single IP address to multiple machines.
Traffic load
Traffic configuration
PAT
Load distribution
OSPF supports a ________-layer hierarchical design.
1
2
3
Multi
You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?
/24, /25, and /26
/25, /26, and /27
/26, /27, and /28
None of these
Which router command creates a standard named ACL called test?
ip access-list test
access-list test
ip access-list standard test
access-list standard test
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?
4
6
8
14
A VTP server switch generates a summary advertisement every _________ minutes.
1
2
3
5
When configuring a router-on-a-stick, the configuration is done on __________.
Physical interfaces
Major subinterfaces
Subinterfaces
Which IGRP command allows unequal-cost load balancing?
variance
load
balance
network
The OSPF process ID is __________.
Locally significant and is the router ID
Globally significant and must be configured on every router
Locally significant
OSPF doesn't use a process ID, but an AS number
Which of the following is stored in ROM? (Choose all correct answers.)
POST
ROMMON
Configuration file
System recovery file
Which type of traffic is sent to a group of devices?
Multicast
Unicast
Broadcast
Groupcast
The root switch is the one elected with the __________ __________.
Lowest MAC address
Highest MAC address
Lowest switch ID
Highest switch ID
Which protocol supports VLSM?
RIPv2
IGRP
RIP and IGRP
None of these
The address of a Frame Relay VC is called a ___________.
Data link layer connection identifier
Data layer connection index
Data link connection index
Data link connection identifier
Which router command specifies the ISDN switch the router is connected to?
isdn switch-type
isdn connection-type
isdn spid1
interface serial0:15
Which router-on-a-stick command defines the VLAN for the interface?
vlan
encapsulation
trunk
frame-type
RIP has a maximum hop count of ____________ hops.
10
15
16
100
A _________ uses Gigabit Ethernet as a media type
WAN
LAN
MAN
LAN and MAN
IGRP generates an update every ___________ seconds.
30
60
90
120
You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?
30
62
126
254
__________ states that if a neighboring router sends a route to a router, the receiving router will not propagate this route back to the advertising router on the same interface.
Split horizon
Poison reverse
Hold-down timer
Hop count limit
Which of the following is a private address?
192.169.7.17
172.32.28.39
10.1.256.8
172.16.255.89
The function of the MODE button is to __________.
Change the status of the ports
Affect what the SYSTEM and RPS LEDs represent
Affect what the port LEDs represent
Change the status of all the LEDs
Frames sent above the __________ limit will have their _________ bit set.
CIR, DE
BC, DE
BC, FECN
CIR, FECN
Which of the following is false concerning CHAP?
It sends an encrypted password.
It sends a challenge.
It is more secure than PAP.
It uses a three-way handshake.
What router command saves the active configuration to NVRAM?
copy nvram startup-config
copy startup-config running-config
copy running-config nvram
copy running-config startup-config
You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
1
5
10
15