Home

The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a router).

A. Demarcation point

B. Carrier switch

C. Local loop

D. CPE

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The switch port that is chosen to forward traffic for a segment is called a __________.
  2. Distance vector protocols use ___________ to disseminate routing information.
  3. Which of the following is not an advantage of route summarization?
  4. Which frame field is different between ISO HDLC and Cisco's HDLC?
  5. Which router command performs an overwrite process? (Choose all correct answers.)
  6. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  7. Which controller command specifies how ones and zeros are represented on a digital circuit?
  8. Which router command clears all of the static translations in the address translation table?
  9. OSPF supports a ________-layer hierarchical design.
  10. The _________ command takes you from User EXEC mode to Privilege EXEC mode
  11. You are given this address space: 172.16.5.0/25. You need one network with 64 hosts and two with 30…
  12. _________ allows you to create this summarization: 10.0.0.0/7.
  13. IOS images can be loaded from all the following except:
  14. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  15. There are _________ actions a router can take when there is a match on an ACL statement
  16. A ___________ is similar to a telephone circuit-switched connection.
  17. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  18. You have this binary value: 11000001. This equates to _____ in decimal.
  19. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  20. Which command defines interesting traffic?
  21. RIP has a hold-down period of ____________ seconds.
  22. You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What…
  23. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  24. A routing protocol will use a _________ to determine which path is the best path.
  25. Which VTP mode(s) will propagate VTP messages?
  26. _________ describe(s) users that can connect to a network from any location.
  27. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  28. Which of the following is a private address?
  29. A __________ topology uses a single connection to connect all devices together.
  30. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?