Home

The MASSPROP shortcut will provide the following information.

A. Mass

B. Volume

C. Bounding box

D. All of the above

Correct Answer : D.


Download Objective type questions of Engineering Drawing PDF

Get all objective type questions of Engineering Drawing MCQ

Also checkout these categories

Engineering Materials MCQ Microsoft PowerPoint MCQ Data Sufficiency MCQ Selenium automation MCQ Fluid Mechanics MCQ Surds and Indices MCQ Word Power MCQ Bio-Chemistry MCQ Softwares MCQ Windows 2000 Server MCQ Series MCQ Problems on Trains MCQ

Please do not use chat terms. Example: avoid using "grt" instead of "great".

Submit
Load More..
You can do it
  1. This means that a feature of a finished product contains the maximum amount of material permitted by…
  2. A line with a tapering width can be easily created by using the __________ tool.
  3. In some circumstances an entire drawing can be inserted into a different drawing as a block. When this…
  4. The edges of a cube in isometric projection make angles of this many degrees with each other:
  5. Newer versions of Auto-CAD utilize the ________ to make block library management very easy.
  6. The View toolbar will position the view of the 3-D solid toward the ________.
  7. This is the plane upon which the top view is projected:
  8. Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point…
  9. Some traditional board drafters preferred the drafting machine over the parallel straight edge because…
  10. This material is used in masonry construction, most commonly for ornamental facing:
  11. When using the direct entry method to create a horizontal line exactly three inches long the drafter…
  12. When the receding lines are true length, and the projectors are at 45 degrees to the plane of projection,…
  13. These are lines drawn on a map to locate, in the plan view, points of equal ground elevation:
  14. This is a thin solid line directing attention to a note or dimension and starting with an arrowhead…
  15. Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
  16. Students can complete an associate's degree in drafting which normally takes about ________ years to…
  17. A partial auxiliary view is used to show only the ________ in the auxiliary view.
  18. The building construction industry relies on sets of ________ drawings to construct homes and commercial…
  19. Baseline dimensions are referenced from a common geometric feature known as a ________.
  20. This type of solid is formed by sweeping a shape along a linear path:
  21. In this type of concrete, the steel is pre-tensioned before the superimposed load is applied:
  22. The condition of a part when it contains the least amount of material is referred to as ________.
  23. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
  24. Which of the following is one of the basic types of welded joints:
  25. This is a curve showing the displacement of the follower as ordinates on a base line that represents…
  26. A fillet is a rounded surface on the ________ corner of a part.
  27. On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
  28. This is the smallest diameter of a screw thread:
  29. Welding drawings are a special type of this kind of drawing:
  30. Most architectural drawings produced for field use by building contractors are printed on architectural…