Home

The maximum tangential stress in a thick cylindrical shell is always _________ the internal pressure acting on the shell.

A. Equal to

B. Less than

C. Greater than

D. None of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The amount of heat required to raise the temperature of __________ water through one degree is called…
  2. The general law for the expansion or compression of gases, is
  3. Kelvin-Planck's law deals with
  4. In a prismatic member made of two materials so joined that they deform equally under axial stress, the…
  5. The fuel mostly used in steam boilers is
  6. In a tensile test, near the elastic limit zone, the
  7. If Th is the torque resisting capacity of a hollow shaft and Ts is that of a solid shaft, of the same…
  8. Which is the incorrect statement about Carnot cycle?
  9. The ratio of molar specific heats for mono-atomic gas is
  10. Slenderness of a column is zero when
  11. The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its…
  12. Euler's formula holds good only for
  13. Which of the following statement is correct according to Clausis statement of second law of thermodynamics?
  14. Flow stress corresponds to
  15. For a simply supported beam of length l, when a concentrated load W is applied in the centre of the…
  16. The deformation of a bar under its own weight is _________ the deformation, if the same body is subjected…
  17. The kinetic energy per kg molecule of any gas at absolute temperature T is equal to (where Ru = Universal…
  18. The value of modulus of elasticity for mild steel is of the order of
  19. A process, in which the working substance neither receives nor gives out heat to its surroundings during…
  20. The property of a material by virtue of which a body returns to its original, shape after removal of…
  21. A column is said to be a short column, when
  22. The neutral axis of the cross-section a beam is that axis at which the bending stress is
  23. The measurement of a thermodynamic property known as temperature is based on
  24. A beam which is fixed at one end and free at the other is called
  25. The stress developed in a material at breaking point in extension is called
  26. In a steady flow process, the ratio of
  27. The calorific value of gaseous fuel is expressed in
  28. The shear force diagram of a cantilever beam of length l and carrying a uniformly distributed load of…
  29. The buckling load for a given material depends on
  30. The general law of expansion or compression is pvn = C, The process is said to be hyperbolic, if n is…