Home

The mutual inductance between two coils is ___ the reluctance of magnetic path.

A. Directly proportional to

B. Inversely proportional to

C. Independent to

D. Equal to

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. At what frequency will an inductor of 5mH have the same reactance as a capacitor of 0.1 F?
  2. Series resonant circuit is sometimes known as
  3. When two unequal values of resistors are connected in parallel across a dc sourcea greater current flows…
  4. Refers specifically to steady state values of quantities in ac circuits which are complex numbers.
  5. A capacitor is used to
  6. If the output resistance of a voltage source is 4 a it internal resistance should be
  7. As applied to a series RLCcircuita bandwidth means
  8. The unit of elastance is
  9. For a carbon composition resistora typical resistance values range from
  10. Voltage resonance means
  11. The mutual inductance between two coils is ___ the reluctance of magnetic path.
  12. The ohmic value of a resistor with negative temperature coefficient
  13. The farad is not equivalent to which of the following combination of units
  14. An inductor carries 2 A dc. If its inductance is 100 Ha then what is its inductive reactance?
  15. What is the total capacitance of 10 capacitorsa each of 20 F in series?
  16. What is the purpose of a load in an electric circuit?
  17. In an ac circuit with a resistive branch and an inductive branch in parallela the
  18. What is a rotating vector whose projection can represent either current or voltage in an ac circuit?
  19. The usual load of a dc circuit is a/an
  20. A gang capacitor is a variable capacitor in which capacitance is varied by changing the
  21. What is the reading of an ohmmeter for a shorted capacitor?
  22. Which of the following capacitors has the highest cost per F?
  23. A linear circuit is one whose parameters
  24. Kirchhoffs laws (KCL and KVL) are applicable to
  25. A capacitor opposes change in
  26. For a linear circuita ___ voltage or current is used to calculate average power.
  27. High resistance values are a consequence of the ___ of the film.
  28. For multi-plate capacitora capacitance is proportional to
  29. In dividing or multiplying phasor quantitiesa ___ form is used.
  30. The factor 0.707for converting peak to rms applies only to