Home

The primary unbalanced force is maximum when the angle of inclination of the crank with the line of stroke is

A. 0° and 90°

B. 0° and 180°

C. 90° and 180°

D. 180° and 360°

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. In order to facilitate starting of locomotive in any position, the cranks of a locomotive with two cylinders,…
  2. The axis of precession is __________ to the plane in which the axis of spin is going to rotate.
  3. The pressure angle of a cam is the angle between the direction of the follower motion and a normal to…
  4. The primary unbalanced force is maximum _________ in one revolution of the crank.
  5. Coriolis component acts
  6. In Meyer's expansion valve, the expansion valve is driven by an eccentric having an angle of advance…
  7. The Grubler's criterion for determining the degrees of freedom (n) of a mechanism having plane motion…
  8. In a steam engine, the distance by which the outer edge of the Dslide valve overlaps the steam port…
  9. In considering friction of a V-thread, the virtual coefficient of friction (μ₁) is given…
  10. The partial balancing of reciprocating parts in locomotives produces
  11. In railway axle boxes, the bearing used is
  12. Open pairs are those which have
  13. Which of the following is a lower pair?
  14. V-belts are usually used for
  15. Which of the following statement is correct?
  16. A governor is said to be stable, if the
  17. Critical damping is a function of
  18. A shaft has an attached disc at the centre of its length. The disc has its centre of gravity located…
  19. A flywheel is fitted to the crankshaft of an engine having W as the amount of indicated work per revolution…
  20. For the brake to be self locking, the force P at C shown in the below figure, should
  21. The length of a simple pendulum which gives the same frequency as the compound pendulum, is
  22. If the number of links in a mechanism is equal to l, then the numbers of possible inversions are equal…
  23. In a reciprocating steam engine, when the crank has turned from inner dead centre through an angle θ,…
  24. The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity…
  25. The static friction
  26. The critical speed of a shaft with a disc supported in between is equal to the natural frequency of…
  27. The magnitude of velocities of the points on a rigid link is
  28. If the opposite links of a four bar linkage are equal, the links will always form a
  29. The pair is known as a higher pair, when the relative motion between the elements of a pair is
  30. The sense of coriolis component 2 ωv is same as that of the relative velocity vector v rotated…